Will the light come on after the water dispenser disinfection switch is turned on?

Will the light come on after the water dispenser disinfection switch is turned on? At present, many water dispensers come with built-in disinfection switches, but some older models cannot set the timer. What should you do if you want to set the timer but don't have it? Let’s take a look! Will the light turn on after the water dispenser disinfection switch is turned on?

It will turn on, but it will not stay on all the time.

If the disinfection light is on when the water dispenser is turned on and the heating light is not on, 99% of the time it is dry. You must not have turned off the heating while you were cleaning it. Your water dispenser was bought four or five years ago. Unplug the power and find a way to open the back cover. There are a few triangular screws that can be fixed with a small flat-blade screwdriver. I see a heating tank inside with two thermostats on it. The bottom one is to prevent dry burning. Use your hands to handle the top one. Just press it and plug it in and it will be ok. What should I do if the disinfection switch of the water dispenser cannot be scheduled?

1. Check whether the switch on the door of the direct drinking water equipment is in the water inlet and non-intelligent control state. Turn on the water and power switches. At this point, water begins to enter. When water comes in, open the faucet. At this time, air is discharged from the faucet, indicating that the drinking water equipment is receiving water normally.

2. When the water flows out of the faucet, pull the switch on the door of the direct drinking water equipment to the normal and intelligent control states. At this time, you will hear the sound of the drinking water machine, which means that the direct drinking water equipment is in a heating state. At this time, the digital meter shows that the temperature will slowly increase until 100 degrees, and there will be water in the faucet, but when the temperature is below 100 degrees, there will be no water. When checking the water supply, even if there is only one link, it means that the direct drinking water equipment in this office building is not suitable for purchase. How to use the water dispenser disinfection switch

1. Preparation: Remove the water bottle from the water dispenser, drain the remaining water in the water dispenser, clean the water inlet, dry the outside of the water dispenser with a towel, and then install it Clean empty bottle.

2. Connect the two silicone ports of the sterilizer to the water outlet of the water dispenser, open the faucet of the water dispenser, select the relay time, clean once a month, 5 minutes each time, every two months Clean once for 10 minutes and once every three months for 15 minutes, this * is for reference only.

3. Turn on the power, turn on the switch, and the sterilizer starts to work.

4. After the disinfection is completed, the instrument will automatically stop, unplug the power supply and silicone interface, put down the wires, close and lock the instrument box, and turn off the water dispenser faucet.

5. Unplug the empty bottle of the water dispenser, fill it with purified water, then pour out about 300 ml of water from the two water outlets, and then drink the purified water in the machine.