How to remove the faucet in the bathroom?

Methods and steps of replacing and installing washbasin faucet:

First, close the water inlet valve.

Please close the water inlet valve before replacing the faucet of the basin. The water inlet valve is generally located under the kitchen countertop. If the valve is not closed tightly or cannot be closed, it can be operated with water. However, when installing a new faucet, the raw material belt with 7-8 turns along the thread direction should be prepared in advance (it is easy to leak if it is missing), and a large bucket should be prepared under the water pipe to receive water to prevent waste; In addition, when the valve can't be closed, be sure to open new faucets and other faucets, and be prepared for diversion and decompression.

Second, remove the basin faucet.

Step 1, separate the water inlet pipe from the hose with a wrench. The water inlet pipe of the bathroom is an open pipe, which can be manually operated, for fear of being accidentally broken during disassembly. Therefore, you need to be very careful when disassembling. Hold the water pipe with your left hand and twist the wrench with your right hand to easily separate the two.

Step 2, remove the fixing piece of the faucet, so that the faucet can be removed from the basin. But then there is a problem. Because the hose of the faucet has been used for a long time, the hose has become brittle and the fixed part has rusted, so it can't be unscrewed with a wrench.

The third step, because the space under the basin is small, the operation is difficult. Moreover, the glass glue between the basin and the countertop has long failed, so the basin can be easily removed from the countertop. After the basin is taken down, the construction will not get in the way. Then saw off the rusty part with a saw, and the faucet was successfully removed.

Third, install the basin faucet.

1. First, put the hose into the faucet and connect it. Then connect the screw to the faucet joint, put the rubber ring on the faucet, then extend the faucet into the basin, and add the rubber pad and gasket. Finally, use a wrench to fix the screw.

2. Because the faucet of the basin is a hot and cold faucet, the internal water valve is a three-way valve, and there is only one water inlet, so only one hose can be connected. The other hose should also be connected to the faucet, but the other end should be blocked. It is recommended to block it with ribbons.

At this point, the washbasin faucet has been dismantled and installed, and the rest is some cleaning and gluing work.