What is the installation of smart locks?

The so-called first step is to remove the traditional mechanical lock on the original security door. If the traditional door lock adopts the "overlord lock body", the smart lock body may be compared from the head, but the number of lock points is not proportional to the safety. The most critical lock points are firm and reliable, and the rest are realized through linkage. The lock body becomes smaller and the number of lock points decreases, which can be said to be shorter and more concise.

measure

The initial installation needs to be measured first, and the lock body of the electronic door needs to be "tried" into the security door after removing the old lock. In the installation process, it is necessary to measure the width and thickness of the door panel and the new lock body. According to the size of the existing door lock and the position of the bolt, it is not too much to say that the installation of the smart lock is destructive.

open pore

After measuring the relevant data, the lock body needs to be taken out, and the steel body of the security door needs to be cut with an angle grinder or grinder. The installation site is full of sparks, resulting in high noise that may disturb neighbors.

Installation and calibration of lock body

All the above are preparatory work, and then the real installation process. First of all, the lock body needs to be fixed, and it needs secondary calibration before it is completely fixed. The position of the lock tongue should match the original door frame, and be accurately measured with calipers and level meters. The most important thing is that the door lock cannot be tilted, and the door lock is not vertically aligned, which does not affect the use and the appearance.

Installing front and rear panels

The seemingly simple panel installation is actually the core of "intelligence". The lock body and the panel need to be fixed with large bolts, and there is a connecting line between the front and rear panels, thus forming an intelligent lock. In addition, waterproof rubber pads need to be installed. If the front and rear panels add the weight of the lock core, it will definitely be heavier than the traditional mechanical lock.

Trial+password

After all debugging, the smart door lock needs to be set. In order to ensure the safety of the user's home, it is necessary to change the original password and enter the fingerprint information of the administrator. Any operation requires a password or fingerprint to determine its administrative rights.

abstract

Measuring and drilling are the most time-consuming steps. If the original keyhole is very small, it needs a lot of time to cut, and calibration needs great patience. Any data error may cause irreparable losses.