What are the regulations on the safety protection of elevator shafts at construction sites?

"Regulations on the Management of Safety Production in Construction Projects"

Article 28 The construction unit shall provide safety equipment at the entrance to the construction site, construction hoisting machinery, temporary power facilities, scaffolding, and access channels. Set up obvious safety warning signs at dangerous locations such as entrances, stairways, elevator shafts, hole entrances, bridge entrances, tunnel entrances, edges of foundation pits, storage areas for explosives and hazardous gases and liquids. Safety warning signs must comply with national standards.

The construction unit shall take corresponding safety construction measures at the construction site according to different construction stages and changes in the surrounding environment and season and climate. If construction is temporarily suspended at the construction site, the construction unit shall provide on-site protection, and the necessary costs shall be borne by the responsible party, or shall be implemented in accordance with the contract.

Extended information:

Elevator wellhead protection standards

Elevator wellheads must be equipped with protective railings or fixed gates, and the protective railings or fixed gates should be standardized , tooled, and its height ranges from 1.5m to 1.8m. At the same time, a horizontal safety net should be installed in the hoistway every 10m and no more than 2 floors.

When installing and dismantling the safety net in the elevator shaft, operators should wear safety belts in accordance with regulations. For holes in floors and roofs with a short side size greater than 1.5 meters, protective railings that meet the requirements should be installed around the holes. A safety net should be installed.

Safety warning signs that comply with national standards should be set up at the entrance of the elevator shaft. The protective railings and gates at the entrance of the elevator shaft should be marked with yellow and black stripes, and should be in accordance with the "Technical Specifications for Safety of Work at Heights in Construction Construction" relevant standards are produced.

Baidu Encyclopedia-Construction Project Safety Production Management Regulations