How to get rid of car stickers

1, the sticker on the glass was sprayed with liquid medicine (except spraying glue, xylene, rosin water, banana oil ...). After the wind oil is applied, wipe it back and forth with soft paper or cloth. If it doesn't drip well, you can also use your fingernails to get it back and forth a few times and then wipe it with a clean cloth.

2, with asphalt cleaning agent, spray with a rag to clean, bring a rag, wet with gasoline when refueling, and then repeatedly wipe the labeled place. Soak the towel in hot water, then cover it and dig hard. Then wipe it hard with a cotton swab and get up slowly. Be sure to work hard.

3. Prepare a high-powered hair dryer and a slightly moist soft cloth, which can help us wipe off a small amount of residual glue on the edge of the sticker. When uncovering the car sticker, make sure that the hot air from the blower always blows on the sticker surface. Therefore, the ideal operation form is to start from the upper left of the car sticker, hold the air duct with the right hand, blow evenly at the position to be uncovered, and slowly lift the car sticker with the left hand.

4. There is no film on the front windshield. You can soak the logo in warm water first, and after soaking, some less sticky signs can be easily torn off. If you encounter a logo with strong adhesion for a long time, you can use a special cleaning solution, such as asphalt remover and multifunctional cleaning agent, and gently wipe it with a towel to avoid being scratched by the blade. After cleaning, you can wash the original bonding area with soapy water several times, and finally dry it with a towel.

5. Don't use the cleaner on the painted glass, because some chemicals may damage the car film. In this case, wipe the logo repeatedly with a towel dipped in a small amount of oil cleaning agent (such as alcohol and diesel oil), but never spray the oil cleaning agent directly on the glass, otherwise it will damage the car film. Alcohol, diesel and other preparations are not corrosive, which can better protect the film, but it takes a long time, so be patient and gently wipe it. In addition, the concentration of alcohol or diesel oil should be maintained when cleaning, and too strong a solution will also be detrimental to glass cleaning.

6. Stickers are complex in shape, so attention should be paid to the direction when they are dismantled, so as to avoid the acute connection between the stickers and try to keep the integrity of the stickers, which is more conducive to speeding up the construction. If the glue is separated from the sticker, the construction should be stopped in time, and the glue at the separation place should be heated centrally, and then removed slowly. After cleaning a short piece of sticker, wipe off the residual glue on the edge of the sticker with a soft cloth while the temperature is still high. If the range is too large, it can be heated again with air duct and then erased.

7. It takes some patience to remove the car sticker. Don't tear the car sticker when it is not fully heated, so as not to cause further trouble when the adhesive falls off. Power: When using the on-board inverter, we must pay attention to the difference between the rated power of the fan and the output power of the inverter. If the blower power is too high, only an external power supply can be considered. In addition, when using the inverter, it is necessary to ensure that the vehicle is in the starting state, otherwise it will easily lead to battery loss.