How to paste the Toyota Cool Road Ze Cai Ze in 2005?

1. Wash the car, and then scrub the place where you want to stick the color bar with alcohol. The most important thing is that there is a dust-free or low-dust environment around.

2. Then prepare a bucket of water and arrange the colored strips.

3. From the front of the car, tear off the color stripes corresponding to the front of the car from the surface protective film (the color stripes are on white backing paper), soak them in a bucket, and then sprinkle some water on the car body. Pick up the colored strips and stick them on the car body (the wetter the car body, the better), and then wet the other colored strips and stick them on the car body in turn. When all the strips are stuck to one side (when the water is still wet), adjust the position by observing to align them. If it is not aligned, you can tear it, then sprinkle water and stick it again.

4. Squeeze the color bar repeatedly with a bank card or plastic board to squeeze out moisture and bubbles.

5. Stick the opposite color bar in the same way.

6. After the two sides are pasted, take a hot air blower and blow it evenly against the white backing paper. Try while blowing, slowly tear off the white backing paper (gently, don't deal with it if you see bubbles in the middle of the color bar). After all the backing papers are torn off, they are basically covered with colored strips.

7, carefully check where there are small bubbles in the material, use a needle to break the bubbles, and then use a hot air blower to blow the bubbles, and use a pressure plate to blow. Deal with all the small bubbles and you're done.