How to stick iqoo stickers?

Let's tear off the paper from the first step, and there is a wet tissue in it. Usually, this screen must be wiped clean before pasting, and there can be no dust particles on it, otherwise there will be many small bubbles when pasting.

Then we tore the second piece of paper, and there was a money cloth inside. After we wipe off the dust with a wet paper towel, we immediately wipe off the water with this dry cloth. If there is a sticker, we will use it to get the dust on it.

Please click to enter a picture description.

Please click to enter a picture description.

Please click to enter a picture description.

Tear off the toughened film of mobile phone.

Next, we will start to tear off the toughened film of the mobile phone. When tearing off the tempered film, the action must be gentle. Tear off a layer of paper from it, then put the sticky side down directly, and then aim at these holes. Be sure to align neatly and slowly put down the tempered film.

Please click to enter a picture description.

Please click to enter a picture description.

Please click to enter a picture description.

Please click to enter a picture description.

Please click to enter a picture description.

Eliminate bubbles

Next, we poke the center of the mobile phone with our fingers, and the toughened film is slowly attached to the screen of the mobile phone. Then, we squeeze out some bubbles at the edge with our fingers. Ok, now we have pasted the toughened film.

Please click to enter a picture description.

Please click to enter a picture description.

Please click to enter a picture description.

Please click to enter a picture description.

Please click to enter a picture description.

abstract

We can see that the sticker is flat and there are no bubbles. Finally, we wiped the fingerprints off it with a wet tissue, and it's finished now.

You can post it at home and it will be done in a few minutes. At the same time, it is also very economical, which is much more cost-effective than the outside 100 yuan.