Water pipe cleaning

Tap water pipe cleaning is to remove dirt, bacteria, etc. in the pipes to ensure the cleanliness and safety of the tap water.

The following are the steps for cleaning water pipes:

1. Confirm the location of the inlet and outlet of the water pipe, close the inlet and outlet valves, and cut off the water source.

2. Open the water pipe drain outlet and remove all accumulated water and debris.

3. Install protective valves at all outlets and openings.

4. Connect the cleaning equipment to the water pipe.

5. Start flushing the water pipes. It is best to use high-pressure flushing to push the water flow into all branches in the reverse direction.

6. During the rinsing process, you can add an appropriate amount of cleaning agent, such as bleach, to make the cleaning more thorough.

7. The flushing time is generally about 30 minutes. For longer times, it is recommended to use professional equipment to complete it.

8. After flushing, remove residual sewage and debris, and rinse the water in the water pipe.

9. Remove all valves, pour plates, and other appliances.

10. Restore the tap water supply and test the flow and quality of the tap water to ensure smooth and clean water.

Warm reminder:

When cleaning tap water pipes, you must strictly follow the above steps to ensure the cleaning effect and ensure the safety and hygiene of tap water. If you cannot complete it independently, you can seek professional water pipe cleaning service providers to perform the operation.