How to paint on wood? What are the steps?

The production of art is not far away. In life, you can make beautiful paintings out of wood:

Step 1: Cut the bought three-layer board into appropriate size with a utility knife (be sure to pay attention to safety when cutting, and the blade will only be pushed out for a short period, and don't use excessive force), and polish it slightly with 400-mesh sandpaper to remove burrs on the surface and corners of the sawdust.

Step 2: Cut off the sharp corners of the sawdust with a medium-sized woodcut circular knife, and carefully polish it with 600-mesh sandpaper until the fingers feel smooth and sharp.

Step 3: Draw a sketch on the paper. I started the manuscript directly on sulfuric acid paper. You can also draft the manuscript on A4 copy paper in advance, and then copy it on sulfuric acid paper.

Step 4: After the draft is finalized, print the draft on the wood chips with carbon paper. In this process, attention should be paid to fixing paper and carbon paper on wood chips to avoid moving. When rubbing, do not press hard to avoid soiling the wood chips.

Step 5: On the line chart, coat a thin layer of white propylene as the base (it must be thin). After drying, the acrylic pigment will form an impermeable film on the surface of wood chips, and then it will not penetrate along the wood grain and damage the picture when coloring.

After brushing the propylene substrate:

After you have a good propylene foundation, you can paint freely.

The color should be thin every time. If you want to have a rich layering, you can apply it more times. After coloring, redraw the lines with Gou Xianbi, otherwise the lines will be blurred under the color block.

After hooking the wire, use a drill to make a small hole in the corner of the wood chip.

Take a pre-woven clover knot, weave 8 diamond knots, then put on ceramic beads, and then continue to weave 2 diamond knots and fix them. Burn the last two diamond knots with a lighter and fix them to prevent them from loosening. Then put in a few small brown wooden beads, tie a knot, burn and fix the end of the rope.

Hang this decorative pendant on sawdust and you're done.

Precautions:

The wood surface must be paved, otherwise the color leaching will be very serious when coloring.