Construction equipment and tools management system?

This system is applicable to the use, repair, maintenance, verification and scrapping of all construction equipment and tools during the installation, modification and maintenance of electromechanical special equipment of the group company. 1, according to the equipment management measures of the group company and the actual construction requirements, rationally allocate construction equipment and tools to ensure that the construction and production requirements are met. 2, equipment operators must be familiar with its performance, operation method and hold the corresponding equipment operation qualification certificate, it is forbidden to operate without a license, it is forbidden to operate equipment without a license and untrained personnel instead of mount guard, it is forbidden to leave work without authorization during the operation, it is forbidden to operate with illness and drinking. 3, at work, other irrelevant personnel shall not contact with mechanical equipment, in case of accidents. 4, construction equipment and tools must be used correctly in accordance with the operating procedures, and shall not be operated blindly. 5. It is forbidden to use the construction equipment and tools without maintenance. 6, it is forbidden to overload operation of equipment, found that the abnormal situation should immediately stop the machine to check and handle the fault in time. 7. After work, clean and lubricate the machine, cut off the power supply and lock the door. 8. The daily maintenance of the equipment is conducted by the equipment managers, technicians, operators and maintenance personnel. 9. The use and maintenance of equipment must adhere to the principle of "paying equal attention to maintenance and prevention", carry out regular maintenance and repair, eliminate found faults, clean, fasten, adjust and prevent corrosion in time, and reduce mechanical wear. The maintenance of the equipment shall be arranged in time according to the maintenance period of the equipment or the actual technical condition. 10, construction equipment maintenance, self-repair ability can be self-repaired, otherwise it needs to be sent to a professional unit for maintenance. 1 1. After the main construction equipment is repaired, it must be verified and accepted, and an inspection certificate must be obtained. 12. If the equipment is damaged due to overload, misoperation or failure, or its performance cannot meet the construction requirements, it should be stopped and marked as "to be repaired". 13. The equipment to be sealed shall be applied according to the procedures, sealed after approval, and an account shall be established; The sealing equipment shall be inspected and maintained regularly by designated personnel to ensure that it is in good condition; Equipment in poor condition should be sealed after maintenance. 14. All construction equipment to be scrapped shall be identified and audited according to the scrapping procedure, and scrapped after final approval. All scrapped equipment shall not be used again.

For more information about project/service/procurement bidding, and to improve the winning rate, please click on the bottom of official website Customer Service for free consultation:/#/? source=bdzd