? There are five ways to solve the waterproof problem in the bathroom easily.

The bathroom is very important because we bathe, bathe and wash in this place. The bathroom must be waterproof, and the wall should be waterproof before laying wall tiles. In general, the waterproof height of the wall is 30 cm, but the overall waterproof height of the non-load-bearing lightweight wall is at least 60 cm. Many citizens often complain that their bathrooms are leaking, which causes the walls to be seriously wet. So, how can the bathroom be waterproof? Let me take you through it in detail.

Waterproof coup in bathroom

1. Be sure to waterproof the wall, and waterproof the wall before laying the wall brick. In general, the waterproof height of the wall is 30 cm, but the overall waterproof height of the non-load-bearing lightweight wall is at least 60 cm.

There are five ways to solve the waterproof problem in the bathroom easily.

2. Pay attention to the seam between the wall and the ground and the seam between the upper and lower pipes and the ground, which is the most prone to problems. Workers must be urged to deal with these edges and corners, and waterproof coatings must be applied in place.

The floor should be waterproof. If it is necessary to replace the original floor tiles in the bathroom, after the original floor tiles are chiseled, the ground must be leveled with cement mortar first, and then waterproof treatment is carried out to avoid leakage of waterproof coating due to uneven thickness.

4. The owner had better ask the decoration team to do a good job of cement root protection for the upper and lower pipes in the bathroom, brush 10~20 cm waterproof coating from the ground, and then redo the ester waterproof on the ground, and add the original waterproof layer to form a composite waterproof layer to enhance the waterproof performance.

There are five ways to solve the waterproof problem in the bathroom easily.

At the same time, the water tank in the wall should also be waterproof. When the pipeline and floor drain pass through the floor during construction, the waterproof layer around the hole must be carefully prepared. Water pipes should be buried in the wall and have a reasonable layout. All laid water pipes should be made into grooves with a diameter larger than the pipe diameter, and plastering in the grooves should be smooth, and then waterproof coating should be painted in the grooves.

5. It is best to use 24-hour "water storage test" to check the waterproofness. After the waterproof project is completed, seal the door and drain, fill the toilet floor with water to a certain height, and mark it. If the liquid level does not drop significantly within 24 hours, especially if there is no leakage on the roof of the downstairs home, the waterproofing is qualified.

Be sure to clean up the ground before waterproofing. In fact, the newly delivered buildings are generally waterproof on the ground, so there is generally no leakage without destroying the original waterproof layer. This is the introduction I brought to you today. If you want to know more information, you can log in to see more relevant content.