UG6.0 is known to have a linear scale of 1: 10. The diameter of the bottom of the cone is 60. How should I draw this cone? Tell me the steps. Thank you. Thank you.

1. Firstly, analyze the cone shape, and the linear ratio is 1: 10. Derive the cone half angle α = ARCTG (110) = 5.7 1 1, choose the Select command from the menu, and input the given parameters: the radius of the bottom is 60, and the height is not given. In this case, the input is 120, and the cone.

2. Create a modeling feature cone. As shown in fig. 2

3. Check whether the cone is compounded with the topic. The measurement method adopts YZ plane sketch detection.

Bottom radius and half angle are both fixed values, which must be entered correctly; The height value is a variable and can be entered as required. As shown in the figure below, the height of 120 can be entered as 12 or 100, depending on actual needs.