Do you want to go to the top or the ground to decorate the water pipe? Don't be cheated.

1. Is the layout of water pipes going to the top or underground?

At present, most water pipes are reconstructed by concealed pipes. If the pipeline is underground, once it leaks, it is difficult to find it in time. Only when other parts of the room or the neighbors downstairs are affected will they be found. General professional decoration masters will suggest that water pipes should be topped. The cost of this design is definitely higher than that of the underground, but it is worthwhile for the long-term plan.

Even if the water pipe leaks, it can be found in time, which is convenient for maintenance and minimizes losses. What are the benefits of above-ground water pipes? After grooving, the ground can stabilize the PPR pipe, and the water pipe line is short, saving materials, convenient installation and economical.

What are the disadvantages of water pipes going underground? Need to slot in the ground, which is labor-intensive. Water leakage is also difficult to find, and maintenance is inconvenient, causing serious losses and even affecting neighbors downstairs.

Actually, whether to walk on the ground or on the roof depends on the specific situation. Now almost all pipes are installed concealed. Some are in the ceiling, which is generally detachable, and some pipes are covered by walls and tiles, which are basically not detachable. Only reducing the pipe joints in non-removable wall and floor tiles as much as possible is an important method to improve the safety factor of pipeline system.

There is no point in blindly climbing to the top. If the pipeline climbs to the ceiling after considerable twists and turns on the ground, and then turns back down, this way causes many joints under the ground, which is not worth the candle. Finally, remind the owner that when carrying out hydropower transformation, it is necessary to choose whether to connect the water pipe to the top or the ground according to the building structure and waterway foundation. If you live on the top floor, it is suggested that the water pipe should not go to the top, because the water flows downwards. The higher the floor, the smaller the water pressure.

At the same time, aerial work requires higher construction requirements, and the welding of pipeline interfaces of workers must be standardized and firm. Elevator should be installed in the top-floor waterway engineering, because water will make the pipeline vibrate when flowing, and elevator can enhance the stability of the pipeline and reduce the noise of water flow.

Second, what are the disadvantages of the water pipe roof?

1, aerial work (hot melt) is strict with the installation master, and the poor welding interface of ordinary workers is counterproductive.

2, the water pipe will go a little more, and the cost is relatively high.

3. Wires and water pipes that are easy to hit other people's homes (because the water pipes pass through the beam) may increase the possibility of making holes in the beam and reduce the strength and seismic capacity of the beam, especially interrupting the stirrups and main reinforcement.

4. The water pressure is reduced.

5. The noise of water flow increases.

6. If it is not firmly fixed in the cement layer, the pipe joint will loosen with the expansion and contraction of the water pipe, thus causing hidden dangers.

Third, how to arrange the water pipes?

1, indoor water pipe installation must be carried out in strict accordance with the prescribed steps. First of all, before installing the water pipe, the owner should have a general plan in mind, and at the same time, he must communicate with the master of water and electricity installation. If there are drawings, the installation of water pipes is relatively simple, just follow the drawings.

2. Then fix the clamp on the wall with an electric hammer, connect the pipes with a special hot-melt machine, and press the whole water pipe line with a pressure test pump. Don't forget to clean up the site after the installation of water pipes.

3. Let's talk about the layout of water pipes. In general, vertical pipes and horizontal pipes should be installed separately. It is recommended that you do not cross-install vertical pipes and horizontal pipes. Under special circumstances, if cross-installation is required, the installation position of hot and cold water pipes should be kept at a certain distance, and more attention should be paid to the height and direction of the drainage pipes, so that the wastewater can flow to the floor drain normally and then be discharged.

For the layout of hydropower, we should pay attention to the specific layout method. The specific layout of water pipes should be designed according to your own needs, whether on the roof or on the ground. Attention should be paid to the specific steps of hydropower layout. It is suggested to invite professionals to carry out the construction to ensure the construction quality and effect, so that it will be more convenient to stay in the future.