How to use usb acquisition card

Users of different models of USB acquisition cards will be different. Let me tell you about the common use of USB. First, it is generally necessary to install the driver of USB acquisition card, and different USB acquisition card drivers are different. After installing the driver, products that generally support streaming media can use commonly used software in the market, such as audio and video, AMCAP WME, etc.

Let me take the same 3D T5 10 as an example to illustrate its usage:

Procurement and installation

Drive installation

Before installing the driver, please check whether the USB interface of the computer is USB2.0. If not, please install it on a USB2.0 machine (or buy a PCI USB2.0 board separately). Try to connect the USB interface behind the computer motherboard, and some front USB will be short of power.

After confirming that it is a USB2.0 interface, connect it from the USB interface of the device to the USB2.0 interface of the computer with a USB cable. When the connection is normal, the computer will automatically find a new hard installation wizard.

1. Select [Install from a list or a specified location (Advanced)] in the pop-up [Find New Hardware Wizard], and click [Next] to continue the installation;

2. After selecting [Include this location (0) in the search], click [Browse] to select the location of the device driver;

3. After selecting the location of the driver, click [OK]. The path [e: \ tswVideo t510-driver] is the path where the device driver is located. Click Next to continue the installation;

4. During installation, a dialog box will pop up, and click [Continue] to install;

5. After the following window appears, click [Finish] to complete the installation of the driver;

6. After the installation, check whether the equipment is normal. Move the mouse to the desktop [My Computer], then click the right mouse button and select [Manage].

7. Click [Device Manager] in the pop-up window, and in [Image Processing Equipment], you can see that ordinary equipment [Syntek STK 1 150] is installed.

If the installed equipment [Syntek STK 1 150] is abnormal, such as yellow "!" "?" , you can double-click the device to update the driver. The specific steps are the same as the above installation. After restarting the computer, there are no other abnormal phenomena, which means that the driver has been completely installed in your computer, and you can run the software and use the device normally.

Application of software

Application under 1 AMCAP

Double-click AMCAP to run the software.

First, select T5 10, as shown below:

Then check the signal source of the equipment, as shown below;

Open [Video Capture Filter] and continue to use the device, as shown in the following figure:

Different signal sources use different ports. Select [S-Video] if you use the Svideo port for input. Usually use the yellow analog interface, and select [Grouping and].

Application of Windows Media Encoder

First run the software, as shown in the following figure:

Secondly, select the device, as shown in the following figure:

Click [Configuration] of signal source equipment, as shown in the following figure:

Click [Video Properties] in the pop-up window, and then click [Image]. Different signal sources use different ports. Select [S-video] if you use the Svideo port for input. Usually use the yellow analog interface, and select [Group and].

Application of sound and shadow

First, double-click the shortcut 【 ULAD Video Studio SE DVD 】 on the desktop, run the software and select Audio and Video Editor, and then select Capture/Capture Video, as shown below:

In [Options/Video and Audio Capture Attribute Settings], set the source switch.

In the input source of the pop-up window, you can switch different signal sources and use different ports. If you use the Svideo port for input, please select [video S-video], usually the yellow analog interface is selected for frequency combination]. The figure below shows.