How to install the toilet

Installation method of conventional toilet:

1. Before installation, take out the plug of the ground sewer pipe, carefully check whether there are sundries in the pipe, and then clean the periphery of the nozzle.

2. The floor on which the toilet is installed must be hard and flat, and floor tiles or other decorative materials cannot be laid. If there is sand and gravel, it should be cleaned up.

Before repairing the toilet, make sure it is level. It is recommended to calibrate with a spirit level.

4. Repair the toilet.

5. Remove the sealant adhered during construction, and it must be removed in time when it is not dry, so as to avoid being difficult to remove after it is dry.

6, connect the water inlet pipe, and ensure no water leakage.

7. Install it for about an hour, and try to flush it several times continuously to ensure that the sewage pipe is unblocked. To test the pollution discharge effect of the toilet, the method is to put the accessories in the water tank, fill it with water, put a piece of toilet paper in the toilet and drop a drop of ink. If it can be discharged at one time, leaving no trace, it means that the water flow is smooth.

8, pay attention to the toilet installation shall not be used within three days, so as not to affect its stability.