Joke Collection Website - Mood Talk - Please tell me something about Raven 2 chassis.

Please tell me something about Raven 2 chassis.

Advantages and disadvantages of raven 1 RV-0 1

Advantages:

1

The movable panel is designed with a buffer, so when you need to use the optical drive, just press it and the whole movable panel will be stored behind the front panel of the chassis. When you want to close it, just press it gently, and the panel will slowly rise until it is completely closed. The screw-free design of the optical drive position is also very convenient.

2

The protruding part below the side plate is an air inlet, and the inner side is provided with a dustproof net. The top panel is ventilated by honeycomb perforated plate, which ensures the heat dissipation efficiency and hides all kinds of messy wires in this area. (The height limit of the cover plate may conflict with some adapters similar to DVI to VGA. It is recommended that users who need it directly use DVI to VGA cable. )

three

The USB interface, audio input/output and an IEEE 1394 interface at the top are dustproof.

four

Innovative internal structure, after 90-degree rotation, the motherboard I/O interface and fan behind the chassis are moved to the top of the chassis. Yin Xin's famous vertical cooling system started from here. Regardless of the price and materials, the internal structure is commendable. The new RV-0 1 has blackening inside.

five

Can accommodate E-ATX motherboard and super-long graphics card.

six

Hot-plug design of the hard disk bit, just plug it in directly, and a 180mm fan (700rpm) is set below the hard disk bit for targeted heat dissipation. The ventilation space under the hard disk space is also dustproof, and it is also convenient to disassemble and clean.

seven

The back of the chassis supports the wiring of the backplane, and the metal buckle for wiring management has been covered with heat shrinkable tubes to prevent the wires from being scratched while insulating, and the wiring holes on the back are also covered with rubber rings to prevent fingers and wires from being scratched during installation. Attaching a fixing strip to reinforce the graphics card can effectively avoid the boot problem caused by loose golden fingers when moving the chassis.

eight

Good compatibility with ultra-long power supply, and there is a pull-out dustproof net under the power supply position, which effectively prolongs the maintenance cycle of the chassis and facilitates the daily cleaning of users.

Disadvantages:

1

The original fan is rubbish, so it is better to replace it. The corner dust problem is a bit serious, and the heat dissipation is not as good as that of Bird 2.

2

The problem of the front wind of the chassis is that the crow 1 is very high, and there is a 18CM fan upwelling under the HDD to dissipate heat. At 5.25, the place is a dead end. If only there was air in this place.

three

The problem of hard disk vibration is a conspiracy of SST. It is estimated that everyone will buy his CP05, and the ordinary SATA cable should be prepared at least 50cm, preferably without ide cable. In addition, the vibration problem of the side panel was also found.

four

In my opinion, the firmness and service life of plastic parts is a thorny issue, just waiting for the feedback from users after long-term use.

five

The front audio interface of Raven 1 is a problem, and the front USB interface is a bit unstable, and the transmission speed is fast and slow.

six

It is difficult to fix the back line, because the position of the back line opening of this box is not very unreasonable, it is already very small, and it is blocked by two motherboards. Only two of the four wiring holes can be used, and two are blocked by the motherboard. If you want to cover the upper cover, all kinds of wiring can only be inserted around the handle.