Toyota Camry wiper replacement tutorial, how to change Camry wiper?

Toyota Camry wiper replacement tutorial: 1. To remove the original wiper, first set the wiper. 2. Press down the clip and remove the wiper strip. 3. Remove the wiper of the original car from one side, but be careful not to let the rocker arm bounce back and break the front windshield. 4. Tilt the front end of the middle clip upward for easy installation. 5. Insert the middle clamp and tighten it! It snaps into place. 6. Install the wiper on the passenger seat and pay attention to the direction! Tighten it until you hear a click. When it comes to wipers, many riders may take it for granted. Toyota Camry wipers account for a relatively small part of the total number of cars. However, according to the international driving safety survey, when driving in rainy days, the traffic accident rate caused by the aging of wiper blades is about 5 times higher than usual. In the season of frequent showers, if there is anything wrong with your wiper, repair or replace it quickly. There are roughly two kinds of wipers, one is the traditional intermittent wiper, which is the most common wiper. There are three or four sections, and the driver adjusts according to the rain and sight. The other is the rain bead induction type, which is mostly used in mid-to high-end models. A good Toyota Camry wiper must be heat-resistant, cold-resistant, acid and alkali-resistant, corrosion-resistant, close to the windshield, reduce the motor load, have low noise, strong drainage, and the windshield is soft and scratch-free. Can make your vision clear. Maintenance personnel suggest replacing the wiper once a year to ensure your driving safety. Toyota Camry's original wiper is a 3-segment wiper. It fits better. So the rubber strip in the wiper was replaced. Related hot search: 1, wiper is dirty and has waterline. 2. Wiper switch uses video 3. How does the wiper stand up?