Is it okay not to sew the tiles after they are pasted?

1.？ From a practical point of view, it is beneficial. It turns out that there is cement or caulking agent in the gap, which is not reliable and resistant to dirt. These two short boards can be avoided if they are beautifully stitched.

2.？ The beautiful seam of ceramic tile is the combination of art and home decoration, which can not only enhance the overall visual beauty of home decoration, but also highlight the quality of life and status.

3.？ Tile splicing is unsightly. After a long time, cracks begin to turn gray. What's more, odors float out and bacteria run rampant, which poses a serious threat to the health of family members. This problem is avoided when the tiles are beautifully stitched.

4.？ If possible, you can do it in the whole house, or in public areas, such as living rooms, restaurants, corridors and other places. If money is tight, you can not do it for the time being, because the sewing agent can do it later.

How to construct the beautiful seam of ceramic tile?

1. Construction method: put the caulking agent into the glue gun, and then slowly and forcefully drive the material into the joint. After laying a joint (about 0.2m), first block the nozzle with a wooden wedge, and then immediately scrape off the sealant with a small scraper or finger. The overflow materials on both sides of the brick joint can be wiped off with a wet sponge, and must be wiped off before the sealant solidifies. After each wiping, the sponge should be washed with water for reuse. If the joint width is greater than 3mm and the caulking agent filled into the joint of ceramic tile is relatively uniform, then it is not necessary to scrape the caulking agent and let it level automatically.

2. Leave a gap with a depth of1mm.. Before using sewing thread, clean the dust and other sundries in the seam with a rag or a fine brush. Stick masking paper on both sides of the seam. It is advisable that the masking paper is about 0.5mm away from the edge of the gap. Put the caulking agent on the glue gun and drive it evenly along the brick joint. Construction is about 1 m, which should be evenly daubed with fingers or a small scraper immediately; When the masking agent is not cured (about 1 m in construction), the masking paper can be removed conveniently.

I believe that after reading Bian Xiao's introduction above, you should understand the importance of tile joints. When choosing this decoration material, try to choose some big brands of tile joint decoration materials. Because the quality of tile decoration materials of big brands is guaranteed, if his family has quality problems, you can contact after-sales maintenance or replacement. I hope Bian Xiao's suggestion can help you choose good tile decoration materials and give you a very good decoration environment!