It's just a pile of noodles How to make noodles will not make jokes. Noodles, I don't know how to make noodles. Thank you.

Making noodles by yourself is very troublesome. It is to mix the dough, then roll it into a dough sheet and cut it into suitable silk.

Handmade noodles

Five steps

Step 1: Mix the dough.

Practice: Add an egg and 1.5g salt to a catty of flour.

Tip: Usually mix flour with cold water, and mix flour with warm water when the weather is particularly cold. Don't add water to the flour at once, just add water slowly and knead the flour together.

Step 2: Knead the dough.

Practice: When kneading dough, grasp the moisture in the dough until the hardness is moderate.

Tip: After kneading the dough, you can cut it with a knife. If there is no raw flour, the dough is kneaded. If you are not in a hurry, you can also wrap the kneaded dough in a plastic bag and wake it for 5- 10 minutes.

Step 3: Roll the dough.

Practice: Use both hands evenly when kneading dough. After the dough is rolled, roll it from front to back with a rolling pin, which is quick and easy. In order to prevent the rolled dough from sticking to the chopping board and rolling pin, you can sprinkle some flour on the dough at regular intervals.

Tip: When rolling the dough, the edge of the dough sheet is easy to be thick. Just roll the edge with a small rolling pin. Reminder: the dough slices must be rolled equally thick, so that they will be cooked together when put into the pot.

Step 4: Overlap the surfaces.

Practice: Roll up the rolled round dough pieces with a rolling pin and stack them layer by layer. Tip: Don't stack it too wide. You can measure it with a kitchen knife at home. The width of the stack should not exceed the width of the knife, so you can cut the plane.

Step 5: cut the plane.

Practice: first sprinkle some flour on the folded noodles, and then cut the noodles with a "push-pull" knife to make the noodles as wide as leek leaves. The so-called "push-pull" cutting method means that the knife should start from below, then cut forward according to the strength, and then pull back on time.