How to install a standard basketball stand

Installation instructions of basketball stand: The basketball court is 28m long and15m wide. It is a rectangular solid plane without obstacles. Buffer zone should be considered during site construction. In principle, FIBA stipulates that the end line area should be reserved for 2m and the sideline should be reserved for1m.

Install the mobile basketball stand.

1. Screw connecting the upright post and the base, and the four screws are not tightened temporarily;

Secondly, connect the lower pull rod "40*60 square pipe" with the base. One end of the mule bar with positive and negative teeth faces down to adjust the height of the rack;

Third, connect the ball ring, below the ball plate and the front end of the extension arm of the column, which is a combination of three things. That is, connect them with screws;

Step 4, connecte that pull rod connecting the leg of the table with the upper part of the ball board, and when tighten, the countersunk head screw on the upper part of the ball board is flush with the surface of the ball board;

5. Open the back cover plate of the base of the ball rack and put in the flat slate or precast slate with a weight of not less than 200kg;

Six, adjust the height and balance of each part of the basketball stand, tighten the connecting screws of each part, and complete the installation.

Installation of embedded basketball stand

1. Excavation requirements: 70cm long * 70cm wide * 80cm deep; After the basketball stand is installed, it should be filled with concrete;

Second, the edge of the basketball stand is 60 cm away from the end line of the basketball court;

Thirdly, the backboard, basketball stand and basketball stand are fixed with four M 12*60 screws. The fulcrum installation of tempered glass backboard must ensure that the backboard is evenly stressed to avoid the backboard from being broken due to uneven stress;

Fourth, install the basketball column, and install the backboard after the concrete reaches the strongest state (about 4 days).

After the basketball stand is placed in the into the pit and its position is determined, the pit shall be filled with concrete, and it shall not be used for three days. Generally, the backboard has 2-4 connecting rods, which are mainly used to adjust the backboard angle and stabilize the backboard. For some special installation positions of basketball stands, such as the roof of a building or the roof of a garage, we can also use embedded bolts to bury the flange in the pit and then connect the embedded parts at the bottom of the basketball stand.