What are the standard dimensions of secondary box protection sheds?

The body of the distribution box protection shed is made up of four sides of 2.4m (height) × 1.96m (width) protective railings. The outer pole of the railing is a square tube with a side length of 30mm and a thickness of 2.5mm, and the inner pole is welded from a square tube with a side length of 25mm and a thickness of 2mm.

The roof is made of special frames of 500mm (height) and 2420mm (width) on four sides. The frame is welded by square tubes with a side length of 30mm and a thickness of 2.5mm. The brackets are made of square tubes with a side length of 25mm and a thickness of 2mm. Made of square tubes. The connection between the shed body and the roof is made up of brackets (25mm×25mm) protruding from each side and embedded into the vertical poles (30mm×2.5mm) of the shed body. The main frame of the protective shed is welded by 40mm×40mm square tubes. The distance between the square tubes of the shed body is 15cm, the total height is 2.8m, and the width is 1.5-2m. There is a fence gate on the front of the protective shed.

Precautions for the use of secondary box protection sheds

The distribution box is exposed to the outside, and leakage and electric shock accidents may occur after being exposed to rain on rainy days.

Prevent objects dropped from height from falling on the distribution box and avoid damaging the distribution box;

Distribution boxes and switch boxes should be installed in dry, ventilated and room temperature places , shall not be installed in gas, smoke, moisture and other harmful media that can cause serious damage, nor shall it be installed in places that are susceptible to impact from foreign solids, strong vibration, liquid pouring, and heat source baking. Otherwise, it should be removed or protected.

Reference for the above content? Baidu Encyclopedia - Protective Shed, Baidu Encyclopedia - Secondary Box