I specialize in home water and electricity renovation. How do I promote it and how do I say the slogan?

Hire someone to design advertisements and slogans for you, and make leaflets to distribute to residents.

Construction Notes:

1. Generally, water pipes can be installed on the roof or on the ground depending on the location. The cold and hot water outlets must be horizontal. Generally, the left side is hot and the right side is cool. The road must be laid straight and level. The layout direction must be safe and reasonable. The position of the pipe clamp and the slope of the pipe should comply with the specification requirements. All types of valves should be installed in correct and level positions for ease of use and maintenance.

2. The water inlet should be equipped with an indoor main valve. Before installation, the water pipes and connecting accessories must be checked for damage, blisters, cracks, etc.

3. The water meter should be installed in a location that is convenient for reading. The distance between the water meter and valves from the wall should be appropriate and should be convenient for use and maintenance.

4. If you install a water dispenser, water purifier, etc. in the kitchen, you should consider leaving the water supply and drainage locations and the power supply location in advance.

5. Both cold and hot water pipes are installed into the wall. The depth of the groove needs to be checked when grooving. The hot and cold water pipes cannot be grooved in the same groove.

The completion of accurate design plans for hydropower renovation is one of the basic conditions necessary for the start of renovation work. It is often blind to start construction in a hurry without a detailed wiring plan for water and electricity renovation. While the water and electricity construction is being carried out, Fang Bu anxiously looks back and forth, thinking about where else to do something. As a result, it is only when the decoration is completed that the completed things are discovered. It’s not useful, and there are still a lot of things I want that haven’t been done.

Another important responsibility that water and electricity designers bear is to make a timely project quantity budget on site based on the completed water and electricity design plan, whether you live in a small residence or a dear villa. The essence of the principle is the same. If the hydropower design and positioning plan is determined, the wiring method will naturally be established. Since the wiring method has been determined, the engineering quantities will naturally be calculated. The accuracy can be achieved to the degree of accuracy, and There are rules to follow. It will be difficult to overspend by writing this budget value and its future deviation from settlement into the relevant signed contracts.