How many days in advance should I make an appointment for subject three?

You can apply for the subject three exam ten days in advance.

You can make an appointment for the subject three exam ten days in advance, but you can't make an appointment three days before the exam. If you want to cancel the exam, you need to cancel it one day in advance. Cancellation or absence on the day of the exam will be treated as unqualified.

If the appointment is successful, the vehicle management office or the test center will send a text message to the candidates about one week before the exam to inform them of the time and place of the exam. If you don't receive the short message of successful reservation, you can cancel the reservation at Traffic Management 12 123 or the traffic safety management platform. But the person who receives the text message needs to cancel the reservation at the vehicle management office.

The examination contents of subject three are mainly: preparation before getting on the bus; Automobile lighting simulation test; Turn on the left turn signal, press the horn, put in gear, step on the clutch, brake and get ready to start; Observe the rear vehicles and confirm that they can be started safely; Drive straight; The operation of adding and subtracting gears; Turn around at the intersection; Change lanes; Through the school area; Passing the bus stop; Cross the crosswalk.

Meet a car; Overtaking; Driving at night; Pull over and wait. Take the exam once every three times, and if you fail, make up the exam for free. If the make-up exam is still unqualified, the exam will be terminated. Subject 31* * has five exam opportunities. If you fail for the fifth time, you need to start the exam again from subject one.

The third quarter matters needing attention:

1. Check before boarding: you need to check around the car before the exam. Generally, there are two sensors on the test car, one in front and the other in the back. When you bypass the car, you need to stop near the sensor to make sure they are sensed by the sensor.

2. Adjustment before operation: Adjust the height of rearview mirror and seat, and confirm whether it is appropriate after adjustment. When looking through the rearview mirror, make sure you can see the rear wheels.

3. Lighting simulation test: The lighting simulation test requires students to master flexibly, master the skills of using lighting during driving practice, and perform relevant lighting operations within 5 seconds after the test instruction is issued.