How to bridge Xuyao ??verification code wireless ap

You can do bridging. The ap needs to be set to routing mode. The setting method is as follows:

The ap and router bridging method:

Main router settings

1. Enter the setting interface of the main router, and then click the running status in the left option bar. You can find the DNS server in the WAN port status bar. There are two in one, the primary DNS and the alternative DNS server. Record them. .

2. Click Network Parameters---LAN Port Settings, set the LAN address of the router to 192.168.1.1 and save it. It will restart and then return to the setting interface and click Wireless Settings--Basic Settings.

3. Set the SSID to TP_LINK_A. Set the wireless channel to: 11. Note: WDS or Bridge function must be turned off.

4. Click Wireless Settings---Wireless Security Settings, and select WPA-PSK as the encryption method. In this example, 12345678 is used as an example. Note: Compared with the old WE encryption, WPA/WPA2 encryption is more secure and the bridge is more stable, so it is recommended to use WPA/WPA2 encryption.

5. Click DHCP Server---DHC Server Settings, set the start address of the address pool to 192.168.1.100; set the end address of the address pool to 192.168.1.149, click Save, and restart the main router. The main router setup is complete.

Set up the secondary router

1. Enter the setting interface of the secondary router.

2. Click Network Parameters---LAN port settings.

3. Set the LAN address of the secondary router to 192.168.1.2 to prevent conflicts with the primary router and to facilitate management of the primary and secondary routers.

4. Click Wireless Settings---Basic Settings.

5. Set the SSID to TP_LINK-B. Set the wireless channel to: 11.

6. Check to enable WDS, click Scan on the pop-up interface, and after getting the AP list, find the SSID of the main router, which is TP_LINK_A, click the connect button on the right, and select WPA-PSK as the encryption method. Fill in the key of the main router: 12345678 (just keep it consistent with the main router), and click Save.

7. Since the new WDS function is different from the old Bridge and is more advanced, you only need to enable WDS on all secondary routers and fill in the information of the main route. For example, if the main route enables WDS or Bridge function, please turn it off, otherwise the WDS function cannot be used.

8. Click Wireless Settings---Wireless Security Settings to set the secondary router wireless password here.

9. Click DHCP Server---DHCP Server Settings, change the starting address of the address pool to 192.168.1.150, and change the starting address of the address pool to 192.168.1.199. For the gateway, fill in the IP address of the main router, which is 192.168.1.1. Fill in the primary and secondary DNS servers with the previously recorded addresses, save them and restart the router.

10. The setting is completed and the connection is successful.