The basic steps of learning to drive.

Before getting on the bus, you must pass the exam of subject one. After signing the contract, you can start the study of subject one, and you can start the study of subject two after passing the exam.

Before studying subject two, turn the steering wheel skillfully, and then you can get on the bus. After getting on the bus, first adjust the position of backrest, seat and rearview mirrors on both sides.

After adjusting the position, you need to fasten your seat belt. After fastening the seat belt, step on the clutch and brake with your feet respectively. Then, hold the shift lever in your right hand and skillfully shift into first gear.

After shifting, turn on the left turn signal, honk the horn, and then observe whether there are pedestrians or vehicles passing by from the left rearview mirror.

Then, put down the handbrake and slowly lift the clutch at a constant speed. If the clutch is lifted too fast, it will make the car shake quickly, which may lead to flameout.

After lifting the clutch, when the vehicle starts to vibrate slightly, you can lift your foot on the brake and start slowly, and release the clutch while stepping on the accelerator lightly.

There is a formula about novice driving:

That is, one step, two hanging, three opening, four pressing, five releasing, six watching and seven loosening. In this way, it is easy to remember the operation steps after getting on the bus, and it will not confuse the order and fail the class.