Introduction to indoor corner anti-collision strips?

What are indoor corner anti-collision strips? At this stage, how do construction companies carry out the construction of indoor corner anti-collision strips? What precautions should be taken? The following is the content related to the professional construction terminology of indoor corner anti-collision strips compiled by the editor of Zhongda Consulting. The basic situation is as follows:

The editor made inquiries through the construction industry encyclopedia website - the construction knowledge column of the Construction Network, and sorted out the indoor corners. Regarding the anti-collision strips, the basic situation is as follows:

Zhongda Consulting takes the installation of anti-collision strips in the corners of underground garage parking lots as an example. The basic situation is as follows:

Indoor columns in the parking lot or Reflective corner guards must be installed on the protruding parts of the passage. Installing anti-collision strips in the parking lot can prevent vehicles and other vehicles from hitting buildings during driving and turning, or from rubbing or colliding with columns, and scratching or damaging the car paint and columns. The reflective film on the surface can also serve as a warning and protection. Even if the driver's negligence leads to a collision between the vehicle and the building, the degree of damage can be reduced.

Scope of application: used in underground parking garages, factory workshops, loading and unloading cargo platforms, both sides of home garage doors, etc. Made of rubber, it is wear-resistant and elastic, and can protect corners, walls and cars from damage. The yellow and black colors are eye-catching, making the parking lot beautiful and tidy, and achieving safety effects. It can protect not only corners or pillars, but also cars. It is eye-catching, economical and easy to use.

The installation location of reflective corner guards is generally installed on parking lot columns, corners, and rear walls of parking spaces. The installation position is 20 cm above the ground at the lower edge of the rubber anti-collision strip.

Installation method: Embed in the parking lot partition wall and the corner of the column, and tighten it in place with expansion tube fastening screws. The operation is very simple and convenient.

Of course, there are slight differences in the corner protectors. Currently we provide two types of corner protectors, one is a right-angle corner protector, and the other is a rounded corner protector. In terms of product durability, rounded corner protectors have better performance.

For more information about the writing and production of bid documents and improving the bid winning rate, click on the customer service at the bottom for free consultation.