Don't underestimate the installation of the sink pipe, it will strike and your whole kitchen will suffer.

In the kitchen decoration, we will encounter the installation of sink. According to the shape and size of the sink, put the sink into the glass and paste it. When installing the sink, the connection between water and water is the most important, and correct installation can ensure normal use. Let's talk about how to install the downpipe. Don't underestimate the installation of the sink pipe, it will strike and your whole kitchen will suffer.

1, the water in the sink is usually purchased at the time of purchasing the sink, or it can be purchased separately. It is more common to use double pots now. The sink has two drainage holes.

The sewer pipe of the sink is generally made of PVC and has a reverse bend to prevent the taste from reversing.

There is an overflow hole on the side wall of the sink. This is to prevent people from forgetting to turn off the tap when no one is at home. Once the whole pool is filled with water, it will flow to the ground. With this overflow hole, water will reach this position. It flows to the sewer.

The sewer pipe of the receiver is connected to the drain pipe and overflow pipe of the sink.

2. When installing the receiver, first punch holes according to the shape and size of the receiver, then put the receiver into the hole, and the surrounding edges will be above the table.

When installing the first faucet in the receiver, put the faucet into the corresponding hole and connect the water inlet pipe below. The entrance hole is left on the wall in advance. In waterway reconstruction, it is best to install angle valves at the joints. At this time, connect the angle valve to the faucet with a hose. Pay attention to installing the hose joint of the sealing washer. Tighten the nut on the hose. After connection, check whether there is water leakage.

3. How to clean the sink pipe and install the sewer pipe. The two sinks of the sink have a drain hole with a basket, and the bottom can be connected with a drain pipe. The drain pipe joint has threaded fasteners, and the two pipes are connected tightly with gaskets to prevent water seepage.

Connect the two sink drain holes to the drain kit connector, and the overflow hole is connected to the thinner drain pipe.

4. Connect the bottom drain hole of the connected sewer pipe to the joint of the waterproof elbow. Be sure to tighten it. There is no tight connection in this place, so it is easy to leak water.

Then insert the bottom end of the drain pipe into the drain hole on the ground. The sewage outlet on the ground is generally thicker than the sewer pipe of the sink. This place is also prone to bad taste. You can seal the drain pipe with something soft to prevent odor.