How to Adjust the Stroke of Punch Machine

1, the adjustment method of punch stroke is to send the workpiece to the designated position of the die, press it down and punch it into the required shape. Feeding can also be divided into manual and automatic, manual one by one. There are also many automatic ways, and a punching manipulator can be used.

2. After the parameters are set, the integrated manipulator for stamping and loading and unloading can automatically perform stamping and loading and unloading operations. In short, the method of replacing manual placement can be called automatic loading.

3. The blanking process of punch is just the opposite. After the feeding process is completed, the next step is blanking. In many cases, this is also done automatically by using the stamping manipulator, and manual operation is slow and dangerous.

4, when found abnormal problems, such as abnormal sound, etc. Before troubleshooting or maintenance, the main power supply must be turned off.

Extended data

Matters needing attention of punching machine

1. After the switch is turned on, run it for 3-5 times, and check whether the operating device and operating state are normal. When stamping, you should concentrate on it, don't trample the pedal at will, and prevent your hand from reaching into the mold or touching the slider with your head, which may cause accidents or waste products.

2. Hard or quenched materials shall not be punched, and the punch shall not be overloaded.

3. After stopping blanking, you must cut off the power supply or turn on the safety switch. Stamping parts and waste should be transported away in time, and there should be no working obstacles around the punch.

Baidu encyclopedia-punch in