What method should be used to install general wall signs?

A commonly referred wall sign is a sign whose indicator is recorded as a visual effect. Conceptually, the sign on the wall should be called the blackboard sign. At first, people called signboards signal forms. Later, through the communication between East and West, they gradually gained the nominal meaning of real symbols. What are the classifications of wall signs?

So what are the classifications of wall signs? 1, sideways: the overall ratio of sideways is longer. Generally, the entire surface is used as an identification mark. It can usually be seen on the walls of small shops and large buildings. 2. Vertical: The whole proportion is relatively long. Generally, the entire surface is used as an identification mark. 3. Protrusions: On the wall surface of a building, except the whole surface of the back or both sides of the wall, both sides are used as identification marks of advertising companies. For example, a three-sided logo. 4. Column: horizontal, vertical and three-dimensional identification marks marked on some fixed structures on the ground. 5. Suspended ceiling type: refers to the installation of some fixed structures on the roof of a building, and the suspension or attachment of square or illusory signs on it. Square or illusory logo.

So, what kind of installation method does the wall-hanging sign have? ? 1. Type of paste This method is widely used. Adhesives used for wall signs include glass glue, double-sided tape, chloroform, structural glue, etc. Select the appropriate adhesive according to different materials and foundations, service time, installation environment, internal and dry and wet appearance, temperature difference and other conditions.

2. Suspension-bonded prostheses are also used for some creases, as if the bottom wall is marble, glass, stainless steel, etc. Therefore, it is not suitable for stamping and is more suitable for this method. Firstly, measure the position, stick AB edge or organic aluminum corner on the wall with glue, then hang the shoulder sign, adjust the position, and use laminated glass safely.

3. Hanging type. The side sign of the wall signboard with large size and heavy weight and foam filling method cannot be installed. First, determine the drilling point, hit it with an impact drill, and nail the rubber plug and self-tapping screw. When only 1 screw is used, it is necessary to drill a hole in the middle part of the marking board to keep it horizontal, and seal the glass glue around it after adjusting the position. ?

4. Decorative screws are fixed in this way. The design draft has clearly pointed out. Usually, wall signs are used to draw with acrylic boards. The positioning of the screw must be accurate, otherwise it cannot be installed correctly. ?

5. Type of pulling the fixing screw This method is suitable for the concrete foundation on the ground without moving the signal. For example, road signs and parking cards are mainly used. The catenary materials used in this way mainly include chains, steel cables, fish slings, cable ties and so on. Use suitable lifting materials according to indoor and outdoor environment, signal weight and other special requirements. Design according to the design. It is required to put the logo in an appropriate position.

These are some questions about the signs on the wall, and you can have a look.

Tubatu Online provides you with "each decoration quotation, 1-4 local decoration companies, 3 sets of decoration design schemes" and the decoration pit avoidance strategy for free! Click this link:/Zhu Ye /zxbj-cszy.php? to8 to _ from = SEO _ zhidao _ m _ jiare & amp； Wb, you can get it for free ~