What kind of glue should be used to decorate the entrance door protective film?

The material used for the entrance door is spray-painted material. It is still sealed with tape, and the flatness will be kept as much as possible when sticking it. Some may use a soft protective film on the outside, but most of them will still be sealed with tape, and the possibility of using glue is very small.

Protection standards for entrance doors

1. The entrance door leaf should be fully wrapped and protected with the company's unified door stickers, and the protective film should be firmly and flatly pasted with transparent tape.

2. The upper edge of the outer frame with the words "Sorry for your understanding" is 1700mm above the ground, and the frame with the words "Sorry for your understanding" on the door is centered on the left and right. If the door leaf is a double door, The "Sorry for your understanding" frame on the door sticker should be on the parent door and the integrity of the pattern should be maintained.

3. Use standard protective film to protect the three sides of the door frame completely and fix it firmly.

4. When removing the protective film after the project is completed, if there are glue marks from the pasting, use alcohol or a special cleaning agent to remove the glue marks.

Door handle

1. When protecting the entrance door, reserve a corresponding hole for the door handle, and use transparent tape to securely fix the door sticker under the handle, and put the standard protective film on Cut into 50mm wide strips and wrap the door handle to protect it. The transparent tape is firmly fixed and cannot fall off during use.

2. After installing the door handle on the indoor door, wrap it completely with plastic wrap and stick it firmly with transparent tape.

Finished product protection standards for windows

1. First, paste the promotional posters produced by the company outwards in the center of the left and right sides of the windows. The lower edge of the promotional posters should be 500mm away from the window sill. The window sill is 1000mm from the ground.

2. Use standard protective film to protect the fixed sash of all exterior windows in the room. The words should face outward and the logo or words on the protective film should be kept horizontally and vertically. The protective film should be laid flat and firmly fixed.

3. When removing the protective film after the project is completed, if there are glue marks from the pasting, use alcohol or a special cleaning agent to remove the glue marks.