What are the safe operation procedures for clearance?

1 When each post enters the production site, it is necessary to wear labor protection articles, and it is forbidden to wear and use irrelevant ornaments and objects. 2. To clean the water tank, it is necessary to empty all the water in the water tank, go through the formalities of the mixed water tank, and cut off the power supply of 407 and 408. Be sure to cut off the power supply. When cleaning, two or more people are required to work, use low-voltage lighting, wear safety belts and safety ropes correctly, and need special supervision. 4 When measuring the cement silo, the central control operator should be informed to stop batching to prevent the measuring rope from falling into the reamer. 5. When the cement silo is inspected and cleaned, the procedures for power failure of vibrators and batching cutters in the cement silo shall be handled, and the power failure and stitching shall be determined. 6. Clean the mud pit, handle the power failure of the propeller, and remove the thread. When cleaning, do not stand on the side wall of the square mud pit for cleaning. 7 When entering the internal cleaning operation of the equipment, the relevant equipment and the previous equipment should go through the power outage procedures, determine the power outage and take out the wiring, use low-voltage lighting at the same time, wear labor protection articles correctly, and work with more than two people, and have special care. 8 In the process of production, used tools, gloves and other related items should be put back in time to prevent potential safety hazards. 9. Non-post personnel are strictly prohibited from entering the work site. When the relevant cooperation posts enter the production site, the safety operation rules of this post should be strictly implemented, and the post personnel should be informed to cooperate in time. * * * Confirm with them. If it is necessary to enter the equipment, they should * * * confirm that the equipment is in a stopped state. After completion, * * * confirm that there is no one in the equipment before resuming production. 10 For the equipment failure, it is necessary to explain it clearly during the shift change, without leaving any problems. 1 1 In the process of equipment operation, when the post personnel leave their posts temporarily, they should communicate information in time, and a special person should take charge of the post, and they can only operate after taking corresponding safety protection measures.

For more information about project/service/procurement bidding, and to improve the winning rate, please click on the bottom of official website Customer Service for free consultation:/#/? source=bdzd