How to replace the high brake light in Tiguan L trunk?

Volkswagen Tiguan brake light replacement steps and methods are as follows:

1. Empty the trunk and lift the pad on the spare tire. Remove the left and right sides. There are eleven self-tapping rivets in the middle, four on the left, four on the right and two on the bottom. There are three on one side of the trunk lid. It is skillful to remove this self-tapping rivet, that is, first lift the small round button in the middle with a tool, and then the rivet can be easily pulled out.

2. Start to remove the plastic plate under the trunk lid and the felt plates on both sides. After removing the three rivets, it is easy to remove the plastic plate. Step 3 remove the lamp holder

Note that when changing the lamp, you don't need to remove the whole lamp (that is, remove the screw), just loosen the bayonet and pull out the lamp cap.

4. Replace the bulbs on both sides.

Turn on the power and compare the brightness of the original light bulb with that of the new LED lamp.

Volkswagen Tiguan's rear fog lights and brake lights are also different. According to the EU ECE R38 regulation, if two rear fog lamps are equipped, the position of the rear fog lamps must be more than 10cm away from the brake lamps. First of all, the driver is easy to respond to the symmetrical lights, and compared with two rear fog lights and one rear fog light, one rear fog light can improve the attention of the rear driver!

Secondly, the rear fog lights are very close to the brake lights, and the two rear fog lights are easily confused with the brake lights. In foggy days, the car behind you can't see the front clearly because of the fog. When it approaches your car, he will see two dazzling red lights. His first reaction was that the front car braked suddenly, and he would immediately brake with one foot, which is likely to cause a series of rear-end accidents. What if the brake lights of Volkswagen Tiguan are always on?

The Volkswagen brake light is always on for the following reasons:

1. After the brake pedal is reset, the switch on the brake pedal fails to turn off.

Analysis:

1) If it was closed, but now it is opened again, it is likely that the piston in the brake master cylinder has not returned;

2) Another possibility is that the return spring inside the brake light switch is weak;

3) If the brake master cylinder lights up after repair, it is caused by improper adjustment of the brake light switch or pedal;

Second, the brake pads are worn.

1) If the induction line is on the brake pad, it may be that the brake pad is worn to the limit.

2) After the brake pads are worn, the piston of the brake cylinder moves outward, so that part of the brake fluid in the brake fluid tank flows into the brake cylinder. After the brake fluid in the storage tank is reduced, the liquid level in the tank is short-circuited by induction, and the driver is prompted on the instrument.