Safety operation procedures for multifunctional loaders?

Rule number one. Conscientiously implement the "General Rules for the Safety of Mobile Machinery" and the relevant provisions on automobile driving.

Article 2 in the homework:

1, it is forbidden to use four-wheel steering on roads and during transitional operations. Turn the steering mode switch to the front wheel steering position when using four-wheel steering or wedge-shaped walking mode at the job site. After the steering wheel rotates clockwise to the limit position, rotate counterclockwise to the limit, repeat for three times, and lock the steering to avoid damaging the steering hydraulic cylinder.

2. It is forbidden to extend and retract the main arm with load at high speed. When the main arm is extended, it is necessary to monitor the torque limiter at any time. When the torque value reaches the yellow area, be careful. When it reaches the red area or gives an alarm prompt, it should immediately stop the operation, retract the main arm and reduce the load torque to the green area. Re-select the safe operation method.

3. When driving with load, reduce the load to the lowest position, and it is forbidden to brake suddenly and turn sharply.

4. It is forbidden to carry out two or more actions at the same time during the operation. When the operation stops, the joystick locking plate must be locked to avoid misoperation.

Article 3 After homework:

1. Check whether the wear block in the telescopic arm is well lubricated, and apply grease on the bottom surface and left and right sides of the telescopic arm.

2. Place the vehicle in a safe place, lower the boom to the lowest point, pull the handbrake and lock the control lever, turn off the engine after idling for 5 minutes, lock the doors and windows, and pull out the battery key.

For more information about project/service/procurement bidding, and to improve the winning rate, please click on the bottom of official website Customer Service for free consultation:/#/? source=bdzd