How to remove the Corolla skylight board?

Pacific Auto Network folds the sun visor down by hand, first disassemble the right side stuck in the hook, take out the screwdriver, and gently pry open the edge of the sun visor stuck in the hook with the screwdriver. Be careful not to pry open the plastic hook or sun visor.

Dismantling the sunroof sunshade is complicated, and it is best to have a professional maintenance technician in the repair shop to operate it, otherwise improper disassembly may cause problems such as skylight leakage.

The tutorial for removing the sunroof sunshade is as follows: First, you need to prepare the screwdriver and t-20 spline for removing the automobile sunshade, and then open the door to prepare for the next removal process.

Fold the sun visor down by hand, first disassemble the right side stuck in the hook, take out the screwdriver, and gently pry open the edge of the sun visor stuck in the hook with the screwdriver. Be careful not to pry open the plastic hook or sun visor.

After prying open the right side, rotate the sun visor clockwise by hand for about 90 degrees. At this time, we will see a small white cover on the left side of the sun visor. Take out the screwdriver and gently pry it off with a screwdriver. Put away the small cover for installation.

Next, we will see that there is a small screw inside, which is used to fix the sun visor. Take out the t-20 spline and remove the screw with the t-20 spline. Next, this step is quite simple. Please take care to put away the removed screws.

After the screws are removed, hold the left side of the sun visor with your left hand and the right side of the sun visor with your right hand, and then disassemble it gently, mainly on the left side, so that the sun visor will be separated from the roof of the car. As long as you are slow and careful, you can definitely do this step.

Pull off the wire harness plug inside the separated sun visor so that the sun visor can be completely removed. It should be noted that this wiring harness plug is very small, so it must be light when it is pulled out, so as not to break the tiny wiring harness.

The removed sunshade should be placed in a soft place to avoid staining or scratching the surface of the sunshade.