Method for manufacturing cola bottle flowerpot

The method of making flowerpots with beverage bottles is as follows:

Method 1:

Tools/materials: empty beverage bottles, scissors, hemp rope, flower soil.

1. Cut the prepared empty Sprite bottle as shown in the figure, and the top is slightly shorter.

2. Unscrew the bottle cap.

3. Drill a hole in the twisted bottle cap.

4. Drill holes as shown in the figure.

5. Take out the prepared hemp rope for later use.

6. Pass the hemp rope through the hole on the bottle cap.

7. Screw the bottle cap back to the bottle mouth with hemp rope.

8. Twist into a ball as shown in the figure.

9. Fill the lower part of the bottle with proper amount of water.

10, and then put the bottle cap side down into the lower half of the bottle, as shown in the figure.

1 1, and then fill the upper part, paying attention to exposing the hemp rope.

12, the hemp rope section exposed outside the coiled flower soil is shown in the figure.

13. At this time, the flowers to be planted can be put in.

14, as shown in the figure after planting.

15. Then fill the flowerpot with water until the hemp rope is covered.

16, water the flowers, let the hemp rope in the soil soak, and the flowerpot transformed by Sprite bottle will be ready. The hemp rope below can automatically absorb water by siphon principle, which saves the work of watering flowers.

Method 2:

First, prepare materials.

Cylindrical plastic tank, preferably with trough bottom, scissors for craft, gardening or kitchen, stained glass stone, marble or decorative stone.

Example: The size of this 500ml pot.

Two. Methods/steps

1. Mark it, cut it from the middle of the flowerpot, and leave a height of 7.5 to 8 cm above the edge of the vase you want. After that, it will be used to cut it into thin strips and fold it.

2. Measure it, and then cut straight and evenly distributed strips around the pot. Cut the clapboards in half, and then continue to cut each clapboard in half, so as to cut out even thin strips.

3. Carefully press the strips outward to form a circle of flat edges.

4、? Turn the pan upside down and put it on a flat surface to ensure that the edges are at the same height.

5. Weave the top of the cloth strip to the top of one side of the cloth strip, and then put the cloth strip under the back cloth strip. Fold it so that the tip of the rod is at the position shown by the arrow in the figure.

6. The next one is folded like this, but this one is woven on top of the other one and passes under the next one.

7. The third one is folded and woven like the first one.

8. According to this pattern, until the last three, press them to the bottom of the next one to finish knitting.

Be sure to keep it neatly folded.