Ground Protection and Maintenance

A lot of money has been invested in the floor, such as laminate flooring, solid wood flooring, ceramic tiles, etc., so we must protect the floor well so that we can save worry and worry. Protection of ceramic tiles and floors The paving of ceramic tiles and floors is also part of the basic decoration. It is often found that no protection work is done during and after the construction of ceramic tiles. The specific manifestations include: the tiles are laid while seaming, and the tiles are just laid. tiles, piles of debris on the floor, walking and stepping on freshly laid tiles, floor tiles, and floors not covered with finished protective films, etc. These will affect the laying effect of the tiles and cause problems with the construction quality of the tiles. Suggestions: 1. For wall and floor tiles, do not rush to joint them when they are not yet dry, to avoid artificial loosening and unevenness of the tiles, which will affect the construction effect. 2. Before the floor tiles are dry and solid, do not walk around or pile debris on them to avoid loosening and unevenness of the tiles. 3. After the floor tiles are laid, use finished protective glue to cover the tile surface. This can not only prevent sand from being worn during decoration, but also effectively prevent paint and other colored liquids from dripping onto the tile surface, causing ground pollution. (1) Slab hollowing: The base layer is not cleaned, the watering is uneven, the bricks are not soaked in water, the cement slurry bonding layer is too large to be used for isolation after air-drying, and the strength of the bonding layer is affected too early, etc. is the cause of hollow drum. The reason for the hollowing of the skirting board is not only the same as that of the ground, but also because the amount of bonding mortar on the back of the skirting board is small and has not been applied to the edges, resulting in hollowing of the corners. (2) The thickness of the skirting board outside the wall is inconsistent: Because the verticality and flatness of the wall plaster exceed the word order deviation, the skirting board is controlled according to the horizontal line when inlaying, so the thickness of the wall outside is inconsistent. For this reason, before mounting, check the flatness of the wall surface, and then process it before mounting. (3) Dirt on the surface of the plate: After the surface layer is finished, the finished product is not protected enough. Putting the paint bucket on the floor tiles, mixing mortar on the floor tiles, and not covering it when brushing grout will cause surface layer pollution. (4) The ground is uneven, the floor tiles are not selected in advance, and the thickness and height of the tiles are inconsistent.

Tubatu provides you with "each decoration quotation, 1-4 local decoration companies, 3 sets of decoration design plans" for free online, as well as decoration avoidance strategies! Click this link:/yezhu/zxbj-cszy.php?to8to_from=seo_zhidao_m_jiare&wb, and you can get it for free~