What are the basic operation steps of a punch press?

(1) First of all, you should be familiar with the basic buttons of domestic punching machines:

(1) indicator light is red, indicating that the power supply is normal; When the green indicator lights up, it means that the machine is normal and running all the time. ② The power switch is the main power switch, and the red indicator light will light up when it is turned on. (3) The motor switch will only run when this switch is turned on, so as to continue the following actions, and the red indicator light will light up after being turned on. (4)Run/ Run position is used for stamping operation, and the green indicator light will light up when this key is reached; Beer level is used for mold adjustment. ⑤ There are two operation keys for stamping operation, which must be pressed by both hands at the same time before the machine can perform stamping operation. 6. The emergency stop key is red, which is used for emergency stop.

② Basic operation steps

① Turn on the power switch (the red indicator lights up at this time). ② Press the green motor start key (when the green indicator light is on). (3) Change "running/beer" to "running". Note: If you point to the beer level, the machine will not run even if the power supply and motor switch are turned on. (4) Before operation, press the left and right green operation keys with both hands to observe whether the mold is pressed down and check the safety performance; If it can't be operated, you need to inform the administrator to repair the machine. ⑤ If the equipment for placing the object to be punched is normal, use the safety clip to correctly place the material or the object to be punched in the mold. ⑥ Press the left and right green operation keys with both hands during stamping operation, and release your hands when the upper die rushes down; If you don't press or continue to punch, you must inform the administrator to repair the machine. ⑦ Take out the stamped products with safety clips and check them: check whether there are any indentation, scratch, deformation, lack of materials, peak sticking, etc. If there are any problems, it is necessary to stop the machine and report to the superior. ⑧ If there is no problem, continue to place the object. ⑨ Shut down and clean: When stopping, press the red stop button first, turn off the power after the green disappears, and finally clean the machine and the surrounding sanitation.

For more information about project/service/procurement bidding, and to improve the winning rate, please click on the bottom of official website Customer Service for free consultation:/#/? source=bdzd