Matters needing attention in tile laying

There are certain methods to stick bricks, so there are many places to pay attention to in the process of sticking bricks. Only when these big and small things are done, the tiles will look good.

Inspection of wall and foundation treatment

Check the foundation treatment of wall and ground before paving to see whether the foundation treatment of wall and ground meets or meets the requirements of tile paving. If it does not meet the requirements, it needs to be rectified and maintained first. If there is no brush, you need to brush first.

Finished product protection work

Pay attention to the corresponding finished product protection before tile paving to prevent other items from being damaged during tile handling and paving; Such as window protection, waterproofing, water and electricity pipelines, etc.

Cement mortar paving brick

When using cement mortar to lay tiles, the dry base should be watered first to prevent it from absorbing the moisture in the cement mortar too quickly, which will lead to hollowing and delamination when the tiles are laid.

Clean up grass roots

Before tiling, the base should be cleaned up. If there are decorations such as lime putty, latex paint and wallpaper on the wall, or dirt on the ground, it must be cleaned up, otherwise the cement mortar will not be firmly bonded with the base.

The floor tiles are pasted inward and outward.

Bricks stuck to the ground should be stuck from the inside out. If there is a slope or floor drain on the ground, pay attention to find the slope according to the drainage direction; The wall brick should be laid from bottom to top, and the bottom brick should be pasted later for the sake of beauty. After the wall tiles are pasted, press the floor tiles again. If it's half a brick, try to put it under it. In addition, one wall cannot be glued to the top at a time to prevent the tiles from collapsing due to excessive weight.

The wall tiles have been fully watered and wetted.

The water content of wall tiles is very high, which must be taken into account when pasting. Before tiling, the base should be fully watered and wetted, and the tiles should be soaked in water for at least 20 minutes before use.