What does the car film say to pay attention to?

1. Before pasting, check whether the window glass is installed in good condition and whether the car glass is complete, so as to ensure the normal operation of subsequent pasting. Before pasting the film, the necessary parts in the car must be covered to prevent liquid from infiltrating.

2. Clean the inner and outer surfaces of the window before sticking the film (focus on cleaning the inner decorative surface and glass sealant area). This is mainly to prevent dirt or other construction quality problems between the thermal insulation film and the window glass after pasting, and to ensure that the film can be combined with the glass.

3. Don't lift the window within 3 days after sticking the film.

4. Do not clean the heat insulation film within one week after pasting, and turn on the defogging line switch.

5. Do not clean the surface of the membrane with alcohol or ammonia solution.

6. If bubbles appear after pasting, they must be treated in the construction workshop within 24 hours.

7. Don't let the air conditioner blow against the membrane, so as to avoid serious heat expansion and cold contraction.

Extended data:

1, professional automobile film should use special film cleaning solution and installation solution, and dilute with pure water, so that the film and glass can achieve the maximum adhesive strength, and will not cause defects such as edge warping and delamination, and achieve long-term quality assurance effect.

2. The car must be free of defects and sundries after film pasting, so professional installation must be carried out in a dust-free film pasting room! The clean room not only has a closed glass door isolated from the outside, but also has a water mist nozzle and air conditioner to realize air dust removal, and the ground has a drainage ditch and special paint to further realize dust removal.

References:

Baidu encyclopedia-car window film