Let's start with the steps that painters need.

1. Enter the site to repair the nail hole of wooden engineering. (Stir and fill with antirust paint and gypsum powder)

2. After drying, fully polish and apply primer.

3. After the primer is dry, polish it, and then apply the primer.

4. After the second primer is polished, the top coat is applied. (varnish topcoat can be washed by hand or painted. )

5. After the first layer is polished, polish the second layer.

Wood ready mixed paint:

1, enter the site to do carpentry and blow putty in a comprehensive batch (it is best to use special universal putty powder. ) Some putty powder used for scraping the wall is rough to save money, and the effect is not good.) When scraping putty, the nail hole has been completely covered.

2. Drying, polishing and priming.

3. After the primer is dried, polish the second primer.

4, polishing the first coat, ready mixed paint can't wash by hand, must spray, so as to reflect the luster, because ready mixed paint is semi-matte. Hand washing is dull.

5. After the first layer is dried, apply the second layer. At this time, it is not necessary to completely polish ... just polish the torn parts of the paint. When spraying, the paint will flow downwards. We call it tears ... it will be thicker after drying. Just grind it flat before spraying the second coat. The second coat will also have tears. At this time, just rinse it with wool. Paint mixing is over.

Scraping wall category:

1. Enter the site to fill the grooves on the wall, the joints between the ceiling and the wall, and the joints between the boards. Wash rust-proof paint, and wash the board with kraft paper and white latex to avoid later cracking. The gap between plates is filled with adhesive powder (gypsum powder, caulking paste) and 80 1 glue. After drying, paste kraft paper.

2. The slotted position of the wall shall be leveled with white cement and glue or gypsum powder and glue, and then pasted with linen to prevent cracking in the future.

3. The first foundation treatment Some cities scrape the whole house with white cement and glue, and some cities scrape the whole house with gypsum powder and glue.

4. The second time can be scraped with water-based putty powder, or scraped with the mixture of Shuangfei powder and cooked rubber powder.

5. Apply the third layer of putty after drying.

6. After drying, polish, check the flatness and make minor repairs.

7. Apply primer and check. At this time, small holes will appear on the wall, which is normal. Just fixing it.

8. Apply topcoat, and apply topcoat twice. ...

... you're finished ... this is the painter's workflow, which may not be detailed ... It can only be said that different people pay different attention to the details when working on the spot. ..