How to solve the problem of pressing the line in subject 2 exam _

Vehicles have become an essential tool for people to travel. Of course, it is necessary to know the relevant knowledge. What I want to share with you today is how to deal with the route problem of subject 2 exam. This may help you. Specifically, there are two kinds of route problems in the subject 2 exam: 1) Because the seat position and height of the candidates are inconsistent, the points indicated by the coach may be different from those actually seen by the candidates; 2) The candidate's steering wheel rotation timing is inconsistent with the body speed, and a slight error will have an impact. In order to solve these problems, the following solutions can be taken: 1) preparation before the exam: candidates need to adjust their seats and rearview mirrors, adapt to the exam clutch, and fasten their seat belts. , to ensure that the preparation work is accurate, no omissions, can not be ignored. If the seat and rearview mirror are not properly adjusted, it will also affect the accuracy of candidates' back test sites; If you are not familiar with the semi-linkage position of the test clutch in advance, it is easy to accelerate, downshift or even stall during the test. 2) Mastering speed regulation skills. During the whole examination, candidates need to pay close attention to the semi-linkage position of the clutch and master the adjustment of vehicle speed skillfully to ensure that the vehicle speed is always slow and even. In this way, under the premise of accurate observation, you can basically turn immediately to avoid missing the opportunity. 3) Strengthen the response to the driving direction, quickly and accurately. At the same time, if the speed is not adjusted, it is better to hit the direction sooner rather than later. Even if the direction is played earlier, it can be remedied by correcting the direction. 4) The timing of correcting the direction is very important. For example, in the process of reversing into the warehouse in subject 2, candidates should find the deviation of the car body as soon as possible, adjust the corresponding direction several times through a small angle, and correct the direction of the deviation in time. These methods can help candidates cope with the problem of pressing the line in the second exam and make the exam more smooth.