Detailed explanation of laying steps of wood-like floor tiles

Imitation wood floor tile is a kind of floor decoration material. Because of its beauty and easy cleaning, it is widely loved and favored by consumers. So, how is the imitation wood floor tile laid? What are the laying steps of imitation wood floor tiles? The following small series will specifically talk about the laying steps of imitation wood floor tiles. Interested friends may wish to take a look together!

Basic treatment

There is dirt on the ground, which must be cleaned up, otherwise the cement mortar will not be firmly bonded with the base. After the grass-roots level is watered and wetted, remove floating sand and sundries. This can make the ground base level flat, and it is not easy to produce empty drums and cracks after the floor tiles are laid.

Pre-paving construction

Pop up the elevation control line around the wall, and play the reticle on the ground to control the partition size of the floor tile. On the basis of drawing design requirements, the color, texture and surface smoothness of floor tiles are strictly selected, and then pre-paving is carried out according to drawing requirements.

Manufacturing level

Before paving the floor tiles, spread plain cement slurry evenly on the surface of the base, scrape the cement mortar with a big bar, and then pat it with a trowel. The thickness of leveling layer should be 2~3mm higher than the horizontal level of floor tile bottom elevation.

Brick laying with patterns

Floor tiles should be laid outside first and then inside. General rooms should be laid inside and outside the control line, that is, starting from the side far away from the door, laying in turn according to the test number, and gradually retreating towards the door.

Replication test

In the process of floor tile laying, leveling test should always be carried out with a level meter. After leveling, the horizontal height is consistent, which can make the finished floor tile beautiful and flat. Therefore, the level is very important.

emphasize

When jointing with jointing agent, the jointing time is generally 24 hours after tiling, that is, after the floor tile is dried and solidified. If the jointing time is too early, it will affect the tiled tiles, resulting in unevenness or loose falling off. Pay attention to the depth of the gap when jointing floor tiles, not only the spacing between wall tiles should be consistent, but also the depth of the gap should be consistent, and there should be no too big bumps.