What causes guitar fringing and how to solve it?

That is, the strings are too close to the frets, and the strings vibrate and hit the frets, causing noise.

1. Delay the aging of the strings

The aging of the strings is an inevitable measure (why not stainless steel? Is it too hard and the neck cannot bear it?) Because due to various reasons, such as hand Sweat stains and moisture in the surrounding environment can cause the strings to rust, so they should be wiped with a soft dry cloth or paper towel before and after playing the piano

2. Maintenance of the piano body

Long-term contact of the right hand with the piano body will cause a layer of dirt to accumulate on the piano body. In fact, its impact on the body is more severe than that on the piano. There are countless bacteria on it, so it should be removed immediately as soon as it is discovered.

3. For medium and low-end guitars, you need to buy a case.

For high-end guitars, you need to buy a case, which makes it easier to store the guitar.

4. Sudden changes in temperature Changes Affect Your Guitar

Sudden changes in humidity can cause damage to your guitar. Usually, you should avoid exposing your guitar to direct sunlight and keep it away from heaters. If the air is too humid, put some desiccant in the piano case.

5. High-end guitars are particularly vulnerable to injury

High-end guitars are made with sophisticated craftsmanship and fine materials, so they are particularly vulnerable to injury. Never place your guitar on a table or floor. Pay attention to the scratches caused by your zippers and buttons.

6. Play the guitar frequently

Allow all parts of the guitar to fully vibrate at any time. This is the best way to maintain the guitar. part.

Extended information:

Cause:

Some brands of guitars will be warped if they are not tuned to the standard tune!

Adjust the height of the bridge, or consider changing the saddle! Adjust the height of the neck and chords! Try adjusting the neck and bridge over and over again until you find the sweet spot. Be careful!

You can adjust the neck and tighten the hexagonal socket on the head! Tighten it bit by bit and try the effect bit by bit! If you turn it clockwise, the strings will be loose, and if you turn it counterclockwise, the strings will be tight. Make sure the neck has a moderate bend, towards the fingerboard! But don't adjust it too much, or the pitch will be ruined!

It was in good condition when I bought it. As soon as the place changes or the weather changes, it will be replaced! This is the principle of thermal expansion and contraction of metal! It doesn’t matter, as long as the weather is warm! Try not to adjust easily! The piano must be protected and not exposed to heat or moisture!

It also has something to do with the strength of playing! Even if you play hard, there will be some damage!

If the quality is uneven, if a certain quality is too high, you can break it off with a strip and use the section to scratch the quality. Originally, there was a certain area where the quality was very good, but after scratching it, it became less polished! Be gentle!

Baidu Encyclopedia-Dapin