The wooden floor in the bedroom is dirty. How to clean up is better? What's the point?

If your hardwood floor is dirty, you may need to use soapy water. Under normal circumstances, we prohibit the use of soapy water as a wood cleaner, because soapy water will damage the wood, penetrate into the gaps between floors, cause the floor to swell or make the lowest floor wet, making it difficult to dry by itself. Nevertheless, we still use it. Clean the hardwood floor and listen to my thoughts.

Step 1

Clean one floor at a time with an old cloth soaked in soapy water, and wipe off excess water and dirt with a dry cloth while walking. Make sure that no water enters the gaps between the wooden floors. If the dirt is stubborn and difficult to remove, then I suggest you have a soft brush at hand, brush it with a soft brush and then wipe it with a soft cloth. Saving water can also reduce the damage to the fragile surface of the wood floor.

Second step

Test whether your floor is waxed. Water will leave white spots on the wax layer, but if the surface is oil, water will penetrate into the bare wood or form bubbles on the surface. Remember that alcohol dissolves shellac; Depainting agent bubbles polyurethane and paint; Paint thinner, nail polish or paint remover will crack the varnish. If there is a layer of wax on the floor, it may look dirty and dark. It may be necessary to remove the wax layer first, and then wax it, which sounds a bit troublesome.

Third step

Use a cloth soaked in alcohol or a special wood floor cleaner to remove any wear marks or black heel marks. Wipe the affected floor with a clean dry cloth. Be careful when using solvents on wood floors, because some solvents will make wood floors black.

Fourth step

When removing grease from the floor, first freeze the grease with a pack of ice cubes or frozen vegetables, and then scrape it off with a paint scraper or scraper. Be careful not to scratch the floor. This method is also suitable for the situation that there is tar on the floor. To remove the traces of crayons (markers or children's drawing pens), you can wipe them with mineral oil, or use a little toothpaste and then wipe them clean with a soft cloth.

Step five

Use special wax remover to remove the old wax layer (if the surface is wax, the surface will look yellow and dark). The use of this cleaner follows the manufacturer's instructions.

Step 6

Clean the whole floor with special wood cleaner. Wood needs maintenance after washing with water, soap and solvent. If you remove the old wax, you need to wax the floor again with a rag or brush, and then polish it with a soft cloth or polishing machine. Please follow the manufacturer's instructions and drying time.

Note: Be sure to test the detergent and solvent on the floor first, because carelessness may make the wood black or damage the smooth surface of the floor.