How to pull the lever of billiards? Why do I always jump up?

As we all know, controlling the cue ball to the ideal position depends on the club method and strength, and different club methods are produced according to the position of the cue ball. So how many hitting points are there on the cue ball and how many strokes can be produced?

Theoretically, n hit points can produce n kinds of marksmanship (N≥ 1K). So when someone says that the cue ball can be divided into more than ten points like a clock, I am also cursing. Indeed, if the cue ball is subdivided, there will be at least twenty collision points. But some hit points are almost useless, can't hit so accurately, and the effect will not be obvious. Therefore, in order to make our thinking clear, simple and thorough, I hope you will accept the following concepts.

1. The cue ball is hit many times, which will produce many effects, but there are only five basic marksmanship methods.

2. Middle pole, high pole, low pole, middle high pole, middle low pole. (This section does not discuss eccentric positioning. )

3. All basic shooting is carried out on the center line of the cue ball vertical table.

4. Any hitting point is not in the vertical center line of the cue ball, which means turning left and right or left, right, left, right, down and right.

5. The concept of eccentric plug can only be fully realized after the cue ball is eaten in the library. In other words, you don't have to eat the library, and you don't have to plug the cue ball with the off-pole.

Conceptual understanding: Using the above five basic strokes, you can completely control the cue ball to go to any position on the table. Just a little higher or lower. That is to say, when you face different angular distances, the hitting point of the cue ball should be adjusted appropriately, instead of being deflected downward, so as to achieve the goal of the cue ball moving.

The following will explain in detail the separation angle relationship between the cue ball and the target ball after they hit the target ball under various rod methods.

1. nonlinear sphere.

Middle stroke-the most basic stroke, and the stroke is the first choice in most cases. Reason: the ball won't float because it is thick. The separation angle is 90 degrees (according to force and distance)

Will produce different degrees of change, need to know carefully) the location of the hitting point, visually slightly below the center of the cue ball. Usually, the center of the cue ball seen by the eyes is actually higher.

High pole-commonly used pole method, when used, the cue ball will rotate forward, and the separation angle is acute. The higher the rod, the greater the force and the smaller the separation angle.

Middle-high pole-the common pole method, the position between the middle pole and the high pole is collectively called the middle-high pole, and the occurrence principle is the same as above according to the height of the hitting point.

Low bar-a common bar method, when used, the cue ball will rotate backwards, and the separation angle is obtuse. The lower the rod, the greater the force and the greater the separation angle.

Middle-low pole-a common pole method. The position between the middle pole and the low pole is collectively called the middle-low pole. According to the different hitting points, the occurrence principle is the same as above.

2. Straight ball.

All basic rod methods have no separation angle when used in straight balls. According to different rod methods, linear or linear extension motion in the same direction or in the opposite direction is generated on the same trajectory. "Does a right angle count as a separation angle? :)"

This is the end of the basic concept of pole method. If you want to master and skillfully use the above pole method, you still need a lot of practice and thinking.

After understanding the basic marksmanship, we need to implement these marksmanship concretely. Many golfers are already quite familiar with the shot method, so how to practice and use these marksmanship effectively?

Basic skills training:

Increase the training of uneven bars in the middle while asking uneven bars to fall, which is commonly called pedaling. At this time, you can use pink balls to increase the fun of practice.

Medium-high shot kick: When using the medium-high shot, you should pay attention to the shot rather than the strength, that is to say, when practicing this shot, the strength of each shot should be the same. Just ask for the change of hitting point. After hitting the target ball into the bag, the cue ball advances one position, two positions, and so on. Until you can control the cue ball to hit the pink ball anywhere you think.

Pedal position of middle and low lever: Practice method, the requirements are the same as above. The difference is the direction. When training with the above method, all bars should be fully pulled, that is, the head of the bar should be pulled to the thumb bridge, so as to ensure that the strength of each bar is roughly the same.

Difficulty: Pay attention to the hitting position. A slightly higher or lower hitting position will have different effects in pedaling practice.

The important thing is to play with your heart, do it seriously and learn to sum up. This is especially true for the ball that is a bit difficult for them in the same position.

In the process of playing, the ball that can score lightly should never score vigorously. When playing, you should be confident, attack purposefully, and don't blindly pursue perfection. As long as you can keep the ball you are afraid of playing firmly, it is an improvement not to think about it in your mind.

I think a master-someone who can grasp the opportunity perfectly, someone who can create the opportunity to clear Taiwan, someone who is accurate, someone who has a consistent attitude, and someone who can accept failure calmly. Because you are facing a person who is as full of wisdom as yourself, the real contest is wisdom, not just skill, so if you lose, there must be reasons to lose. Wake up, you will make new progress.

How to ensure more goals in one shot? To sum up, the following tactics are mainly adopted:

1) Don't try to score after kick-off. Break your balls first. Pay attention to which balls are dead or hard to play. Those balls should be played first.

2) Let the opponent catch the ball first. The fewer balls he has, the easier it is for you to play. He is at his best when he has only one black ball left. You can defend one shot first, and then catch the ball with two shots. However, this method also has risks, and it is best not to use this trick to deal with experts.

3) Every time you score a goal, you must accurately control your position, kick the dead ball and leave an angle to lay the foundation for the next ball. Remember, you don't hit a ball, you hit a bunch of balls, and if one of them can't get in, you can't win, so be sure to aim accurately.

4) Don't play the easiest ball every time. The result is often that after playing several times, there is no ball to play. In the initial stage, it is a common method to hit the ball that can clear the dead ball position, such as hitting the ball pile with a thin bottom bag or a middle bag. In the stalemate stage, it is more important to leave a good ball before rushing to the dead ball. Otherwise, the dead ball rushed out but missed, wouldn't it be miserable?

5) Try not to hit the ball far away from the pocket. If you hit the ball in the center of the table, it will be much easier than hitting the bottom pocket.

6) As long as you can hit the ball, there is no impossible angle. Try not to blind the ball. Facts have proved that playing the edge ball often leads to failure. You should use tactics such as rebounding, rotation and borrowing the ball to create goals. It is easy to estimate when the pull rod is played, because it is accurate and obeys the law of reflection. Be careful not to let the bouncing ball hit the cue ball. The hook is more difficult, but it is a skill that most people don't pay attention to, and sometimes it is very useful. The target ball is close to the box and it is easy to hit the rebound hook. Spin (stick) is usually used to bypass the obstacle ball. As long as the angle of the stick is added to the side spin, you can hit the side spin. This is too high and too deep, and it is usually only used to save the ball. Borrowing power is a good idea I recommend, that is, if the direct route of the target ball is blocked, it can make the target ball hit other balls nearby and change its route into the bag. If you play this kind of ball too much, you will master the angle and strength.

7) Avoid the cue ball falling into the bag or accidentally hitting the black ball into the bag. As long as it is possible to make the cue ball fall into the bag, it should be avoided by rotation. If you reduce the chance of blinding the stick, you reduce the chance of blinding the black ball.

Finally, we remember that we play billiards with eight balls, not every ball. When you can clear the table in one stroke regularly, you will find that this sport is actually very charming.

For billiards: in the process of playing, some people can play right and some people can't, or I can play like this, which is particularly handy. I couldn't play well like that, and I made more honest mistakes. I believe everyone should feel this way. In fact, if we look at this problem from a physical point of view, we may gain something. As we all know, the diameter of billiards is smaller than the diameter of the bag mouth. As long as the ball is within the allowable range of the pocket, the ball can generally be put in the pocket. By pushing back, we just need to ensure that the ball is within such an error range. How to ensure that the error of the ball is as small as possible? I looked up a lot of information and found that when we play ball, we don't look at the cue ball, but at the target ball. Judging from our standard posture, the club is generally under the chin, between the eyes, as long as we can see the midpoint of the pocket and cross the target. Some people say that you can hit the ball directly or with a particularly small angle, but you can't hit it with a big angle. In fact, this problem is very easy to solve, that is, considering the radius of the cue ball, after the cue ball collides with the cue ball, the cue ball runs in a straight line, which is equivalent to the extension of your rod. At this time, although you are aiming at the right point, if you look carefully, you will find that the cue ball can't hit the point you are aiming at, that is to say, it is not your rod that touches the target ball first. Therefore, if you kick off properly, you can hit the ball accurately after a period of training. The purpose of this is to hit the ball with a medium stick on the premise of correct posture.

How to hit billiards: When it comes to aiming, some people may say, what if I miss the shot and the trajectory of the target ball is an arc? This question varies from person to person. Some people say don't let go of the key points, others say let go of the key points. Personally, I don't think it is necessary to put some points in the process of hitting the ball, but it is necessary to put some points in the process of tying the rod, because the eccentric rod runs in an arc, but it leaves the straight track in the middle and returns to the original track when bypassing the obstacle. As long as the club is properly used, you can hit the ball accurately. However, the pull rod must give way, thinking that the running track is a combination of straight lines and arcs. The direction has changed. There are not many rules, but more contact is needed to improve the accuracy. All these show that the rational use of the pole method can play an amazing role.

Generally speaking, cue ball is divided into nine zones, and the hitting of each zone is named as:

The middle stroke, hitting the middle of the ball, can completely transfer energy to the target ball, while the cue ball is static and conventional.

A high ball, hitting the top of the ball, can completely transfer energy to the target ball. The cue ball is stationary first and then rotates forward, commonly known as heel.

Low shot, hitting the lower part of the ball, can completely transfer energy to the target ball. The cue ball is at rest first, and then rotates and runs backwards, commonly known as the shrinking rod.

Left wing, left side of cue ball, with arc.

Right off the pole, hitting the right side of the cue ball, there is an (arc.

Right low, hit the cue ball to the lower right, and the running track will appear first (after hitting the ball, hit the low).

Left low, hit the cue ball to the lower left, similar to the above situation.

Right high, hit the cue ball to the upper right, similar to the above situation.

Left high, hit the left cue ball, similar to the above situation.

That's all. Of course, there are advanced pole supporting techniques, such as jumping and tying.

The key point of jump shot is to aim at the center of the ball, generally hitting the middle and upper part (or hitting the lower part) to make a force and quickly draw the ball.

The key point of tying rods is to master the principle of parallel lines.

The power of billiards: when hitting the shot, choose the power according to the distance of the ball and the needs of the situation.

Choose different balls, different positions and practice with the same rod method;

Choose the same ball, a fixed position, and practice with different strokes;

There are also systematic trainings, such as crosses and snake colors.

When these are all practiced, you can start to code the ball and practice your golf skills in the game. When your golf skills are mature, you should exercise your ability to control the overall situation. A simple practice method is the free kick training method, which is to give yourself an arbitrary free kick after the kick-off, and then force yourself to make a hard shot to clear the table. If you make a mistake, start over. Until the station can be cleared frequently.