What work should be prepared before and after copper products processing and copper door welding?

Bronze doors is a luxurious porch with exquisite craftsmanship and good practicability. Copper doors and copper products are exquisite in craftsmanship, mainly carved with relief patterns and auspicious patterns, and they are timeless and deeply welcomed and loved by people.

Of course, the welding process of copper doors and copper products is also very important, because the welding quality will directly affect the assembly quality. Therefore, when welding, the copper joint strictly requires controlling the gap at the welding place. Next, let's talk about some preparations before and after the processing and welding of copper doors and copper products:

1. What are the preparations for processing and welding of copper products?

1. Assemble the welded joint, check it by special personnel, and then hand it over to the welder for welding.

2. Before welding, it is necessary to check whether the scaffold at the welding position is safe, reliable and complete.

3. Clean the welding groove area, and then put the covered electrode welded with insulating cylinder into the welding site.

4, welding protective equipment remember to bring, so as not to cause harm to the human body.

2. What are the precautions for copper products processing and welding?

1, copper products processing and welding, copper door factory can adopt symmetrical welding method. Butt welding, vertical welding and oblique welding are all symmetrical, and this welding method is to avoid welding deformation.

2, copper products processing in the welding process, as long as the weld slag and spatter are found, they must be removed immediately, and when defects are found, they must be polished with directional grinding wheel.

3. After this solder joint is welded, clean up the site just welded, and then transfer it to the next solder joint for welding, so as not to affect the welding quality.

Finally, the inspection of copper products after processing and welding. After all welds are cooled, the appearance of the welds shall be checked, and there shall be no cracks in the copper products.