What are the storage methods of the main line? What is the connection between the main line and the pole tip?

What is the main line of fishing? The main fishing line refers to the section where the fishing rod connects the lead pendant and the swivel, and it also connects the space bean (fixed floating seat), the floating seat (fixed floating seat) and the lead leather seat (originally around the lead leather, but also with the lead pendant). The main line is also called the big line, which probably means thicker than the sub-line. The purpose is to give up the auxiliary line when it hooks underwater sundries, so as to protect the safety of various small parts and fishing rods in the main line.

What is the way to tie the main line to the pole? Main line is a very important type of fishing line, because they play a very important role in fishing, so it is a key issue whether to choose by yourself or connect with other fishing gear. Generally speaking, when the main line is used, it should be slightly connected to the pole, that is, the line is connected to the pole, and the following methods can be adopted:

Handling of rod and rope: firstly, handle rod and rope in a certain way. Rod rope refers to the rope wound around the rod, which needs to be tied in double knots. The shorter the rope, the better. If it is too long, it will easily lead to messy lines after connecting with the main line. Processing mainline: mainline needs post-processing.

Take a suitable main thread, fold it in half at the top with a spacing of about 10 cm, and then tie a knot to make a coil. Connection: After processing, it is a connection. Connect the coil with your fingers and put it on the rod rope. You need to take it off after use, just pull out the thread.

Secondly, talk about the storage mode of the main line. The earliest method is to connect the hook with the lead base and directly roll up the wire board. Later, I changed the spool, but I still felt trouble; The wire is directly wound with lead skin and finally fixed with a pin. Not only is it too complicated, it is easy to hurt the main line; Especially thin lines. Through groping, I summed up a set of my own methods. On one side of the spool, I made five or six cuts with a knife.

The specific storage process is as follows: cut the sub-wire, and put the eight-character ring and lead seat into the waist eye of the spool; Two space beans are opened at the upper end of the lead holder, and the main line is introduced into the wire slot of the bobbin through the peripheral incision; Finally, the tail end of the main line is stuck into the incision of the spool, and the work is completed perfectly!

This method is convenient and safe, but it also has two disadvantages: first, it is necessary to cut the sub-wire, which is not convenient to wrap it with a hook, which may lead to certain consumption. (In fact, there is no consumption after careful calculation. Second, you can't use a lead seat that is too big, otherwise it will be difficult to put it at your waist!