If there is an exam for subject three, what are the steps for subject three?

1. After entering the examination area, candidates should stand by and watch the cab door of the vehicle and report to the examiner: Hello, examiner, candidates are applying for the subject three exam. The examiner issued a test password to the candidates: please get ready to get on the bus.

2. Candidates should start from the cab of the vehicle and circle the vehicle counterclockwise in the direction of "left-rear-right-front-left", carefully check the vehicle and safety conditions, and then report back to the original position: the inspection is completed. The examiner issued an instruction to the candidates: get on the bus.

After hearing the instructions, candidates must observe the traffic situation in the rear before opening the door, and open the door and get on the bus after confirming safety. When getting on the bus, the right leg should enter the cab first, and then lift the left leg after sitting down.

Examiners should check whether candidates observe and understand the surrounding environment of vehicles before boarding, eliminate traffic safety hazards around roads, and check the appearance, tire pressure and boarding process of vehicles.

In the process of inspecting the vehicle and returning to the cab door to report the completion of the inspection, the inspector should carefully observe the behavior, walking, eyes, words and expressions of the inspected. And make sure that there is no abnormality in their physical and physiological conditions before issuing a "please get on the bus" password to the candidates. If any abnormality is found, the inspection shall be stopped in time.

Second, start:

1. Candidates should close the door before starting the engine, adjust the driver's seat and rearview mirror, check the instrument, fasten the seat belt, and report "ready" after starting the engine. After the examiner determines that it is safe, he should issue an instruction to the candidates: Go.

2. After the examiner approves, step on the clutch, put in the first gear, turn on the left light, honk the horn, look at the left mirror and release the brake. If there is a car behind, you can go straight for a while and then merge. If there is no car, merge left and go straight. When starting, do "one step on the clutch, two shifts, three turns, four horns, five rearview mirrors, six loose brakes, slowly lift the clutch and lightly refuel; Turn to second gear. "

Candidates can't start until the examiner gives the start instruction.

At the beginning of the exam, the examiner should focus on testing the development of traffic safety awareness of candidates before departure, pay attention to observing whether the behaviors of candidates before departure meet the requirements of the project, and timely discover and correct the behaviors of candidates who did not fasten their seat belts before departure, improperly adjusted rearview mirrors, unable to start due to insufficient brake pressure, failed to close the doors before departure, and failed to turn to the left and observe traffic conditions through rearview mirrors.

Third, the straight line:

When driving in a straight line, the examiner should issue the instruction of "driving in a straight line" according to the road traffic conditions, so as to examine whether the candidates can keep the vehicle driving in a straight line and whether their attention is evenly distributed.

Candidates should ensure the safe speed and distance of following the car in the process of driving in a straight line, know the driving speed of the car, pay attention to the road conditions and take corresponding measures. There should be no swaying and unstable direction.

Shift gears according to road conditions. Generally, the third to fourth gear is enough. If the road conditions are ideal, you can add it to the fifth gear, but remember, you must control the speed and don't exceed 50. Villages, schools, crosswalks and bus stops must slow down! If it's third gear, just release the throttle. If it's fourth or fifth gear, just tap on the brakes. Moreover, just remember to look at the left and right rearview mirrors every 20 seconds, or you will be deducted 10 if you are not strict.

Upshift sign: one liter and two (10km); Two liters and three (20 kilometers); Three liters and four (30 kilometers); Four liters and five (40 kilometers).

Downshift signs: five minus four (30km), four minus three (25km), three minus two (20km) and two minus one (10km).

Fourth, change lanes:

When the test vehicle is driving on more than two motor vehicle lanes in the same direction, the tester should issue a "lane change" instruction according to the road traffic situation. Candidates should observe the rear road conditions through the inside and outside rearview mirrors when carrying out lane change instructions, and the observation actions should be reasonable and effective.

Examiners should pay attention to the rationality of the examinee's line of sight shift, and focus on cultivating the examinee's safety awareness when changing lanes.

Five, through the intersection:

When the vehicle meets the intersection ahead, the examiner should give the examinee the instruction of "crossing the intersection" at a distance of150m. Candidates should understand and master the rights and obligations in advance and use them accurately when driving a vehicle. Remember to pull the handbrake first and then go back to neutral when stopping at a red light. When passing the intersection, candidates should slow down, honk their horns and make obvious lateral head movements to accurately observe the surrounding situation.

Assess candidates' consciousness and safety of observing traffic safety laws and regulations when crossing intersections, and observe candidates' driving ability of slowing down and observing before crossing intersections.

Six, through the crosswalk line, through the school area, through the bus stop:

When a vehicle encounters a sidewalk, a school area or a bus stop sign while driving, the examiner will issue three instructions to the candidates: "Crossing the crosswalk", "Crossing the school area" and "Crossing the bus stop", which is150m away from the above location. When carrying out the above three instructions, candidates should slow down, ring the signal and make left and right observation actions. To prevent pedestrians from crossing the crosswalk. Candidates should strictly implement the principle of safe driving, so as to achieve uniform distribution of attention and reasonable transfer of sight.

Check whether the candidates slow down when driving on the above sections and observe the left and right sides, especially whether pedestrians stop to give way when crossing the crosswalk, and observe whether the candidates' attention is evenly distributed and whether the line of sight is reasonably shifted.

VII. Meeting:

When a vehicle is driving on a road without a central isolation belt or a central line, the examiner will issue a "meeting" instruction, and candidates should strictly abide by traffic safety laws and regulations and drive in a civilized and courteous manner. In the process of overtaking each other, keep a lateral safe distance.

Examine the candidates' skills in observing the provisions of traffic safety laws and regulations, the professional ethics of civilized driving and comity, and judging the lateral safety distance between vehicles of both sides in the process of mutual concession.

Eight, overtaking:

When the vehicle is driving, when the vehicle ahead is driving at a low speed and the road is in good condition, the examiner will issue an "overtaking" instruction. Candidates should observe the traffic situation on the rear and left side through the inside and outside rearview mirrors, accurately choose the overtaking opportunity and the safe distance between overtaking and being overtaken, and ensure safe overtaking.

Check whether candidates can reasonably divert their attention, meet the requirements and drive safely during overtaking.

Nine, turn around:

When there is a U-turn sign in front of the test section, the examiner should fully observe the oncoming traffic in the opposite lane and issue a "U-turn" instruction in time. Candidates should proceed from the principle of safe driving, accurately choose the timing and location of the U-turn, and must not hinder the passage of other normal vehicles and pedestrians during the U-turn.

Remember to turn on the left turn signal when you see the U-turn sign (the rule is to turn on the light within the range of 100 meters to 50 meters, sooner rather than later). Slow down and downshift to the first gear before turning around. Pay attention to the left mirror to observe the rear car condition, pay attention to the opposite car condition, and be careful not to grab the line. If the driveway is narrow, you can fight right and then kill left, so you won't hit the curb. Turn your back and turn right.

Focus on whether the candidates have chosen the right time and place to turn around.

Ten, pull over:

1. After completing the prescribed examination items, the examiner issues the instruction of "pull over". When candidates are ready to stop after hearing the instruction, they must turn on the right light and look at the right rearview mirror (there must be obvious shaking of their heads, otherwise they will be mistaken for not looking at the rearview mirror), observe the surrounding environment and determine the parking position. After parking, the distance between the vehicle and the right edge line of the road or the edge of the sidewalk should meet the specified requirements.

2. After parking, first pull the brake, then return to neutral, turn signal returns to normal, and turn off the engine. Before opening the door in the car, first look at the left rearview mirror (do lateral head movements), observe the traffic conditions at the rear and left, and then push the door and get off. When you get off the bus, close the door. When parking on the roadside at night, turn off the headlights and turn on the warning lights, and take safety protection measures to avoid accidents.

Check whether the candidates violate the parking regulations of traffic safety laws and regulations during parking, check whether the candidates' sight shifts reasonably before parking, and check whether the candidates' operating skills meet the requirements during parking.

Eleven, driving at night:

When assessing night driving, it is mainly to assess whether candidates can abide by the provisions of the Road Traffic Safety Law and its implementation regulations, and whether they can correctly turn on and use lights when driving at night.

Candidates should be familiar with the relevant laws and regulations of night driving and master the skills of turning on and using lights correctly.