Can the flue of gas water heater be perforated from the glass window?

It is best not to punch holes from the top of the glass. The flue pipe of water heater vibrates to a certain extent, and the flue gas temperature is generally high, which may cause insecurity. If there is no suitable position, the glass window can be punched with a smoke pipe and needs to be sealed with a sealing material (heat-resistant tin foil material, etc.). ) prevent waste gas from flowing back after punching. It should be noted that toughened glass cannot be punched, and it can only be toughened after punching.

Extended data:

Matters needing attention in installation of gas water heater

1, pay full attention to the height, neither too high nor too low. Because if the installation is too high, the water pressure will decrease and it will be difficult to enter the water. But if the installation is too low and the water pressure is too high, it will cause damage to the water heater. Generally speaking, the ground distance needs to reach 1.2- 1.4m, and the water pipe needs to reach1.8m. ..

2. Pay attention to the requirements of power supply when installing. In general, choose 220 volt single-phase three-wire circuit. In terms of wires, 2.5 square copper wires are basically selected, and the current carrying capacity can meet the requirements. When wiring at the same time, the connector must be completely connected in place.