Who can tell me the tips for customizing kitchen cabinets?

When customizing integrated kitchen cabinets, you should pay attention to the following aspects:

1. Based on the principle of design first, measure the scale before the decoration workers enter the site. According to the specific conditions of the kitchen and the customer's requirements, Axis drawings are required. What we need your help here is to prepare the dimensions of the refrigerators, microwave ovens, sinks, range hoods, kitchen appliances and other electrical appliances that you plan to place. It is impossible to know the dimensions in the medium term.

2. You can put forward modification suggestions based on the provided drawings to make the cabinet shape more in line with your wishes. After the drawings are modified, go to the site again, coordinate with the decoration personnel, and provide you with water, gas, smoke, etc. rectification suggestions for pipes, pipes, etc., and mark the reserved locations for flues, sockets for various electrical appliances, and water supply and drainage to avoid adverse consequences caused by random arrangements. You can also mark areas that do not need to be tiled.

3. According to these plans, after the wiring, water and tile laying, etc. are completed, go to the site for the third time to take measurements and make the actual shaft side drawings. You can then sign the contract and pay for the production. The construction period is usually 15-20 days for delivery and installation.

4. Measure the countertop of the cabinet after the cabinet is installed. This can ensure the rationality of the size and give you enough time to choose the matching color of the countertop.

Scale measurement:

1. When measuring the length, it is best to measure twice, from left to right and from right to left, to avoid misreading the size the first time.

2. When measuring the height of the ceiling, measure several quasi-height points in different directions and check whether there are any beams under the gusset plate.

3. When measuring, look at the height from the bottom of the motor socket to the floor tiles, and at the same time look at the height of the window (pay more attention when re-testing).

4. When measuring, measure the distance and height of the gas meter and pipes from the wall, the height of the flue, the height of the water inlet and outlet, the distance of the drainage main pipe from the wall, the height of the socket (when re-testing), etc.

5. When measuring, you should check whether there are steps on the ground and whether there are concave and convex beams on the wall. When making a wall cabinet by the window, you should consider the pull of the screen window. If it is related to the cabinet, you should measure the relevant dimensions.

6. When retesting, the floor tiles must be laid, the wall tiles must be well pasted, and if the wall cabinet or high cabinet reaches the top, the ceiling must be hoisted before retesting.

7. When measuring special-shaped or polygonal shapes, it is best to select fixed points and measure diagonals. When making cabinets (floor and wall cabinets) against the wall on both sides, it is also necessary to measure the inside and outside distances.

8. When there are defective tiles, measure the distance and height from the wall (including the height from the bottom and top to the ground). It is best to leave 700MM in length for normal refrigerators, and additional length for special ones.

9. Where there are door pockets, the thickness of the door pockets (including lines) should be measured, or where there are sliding doors on the floor or wall cabinets, the sliding doors should be opened and a gap of 10-20MM should be left.

10. For example, when measuring the kitchen of the unit, be sure to ask whether the wall is made of stone plastic board to avoid failure to install the wall cabinet.

Hope it can help you~~~